holden 202 inline 6 inlet manifold porting

[@Classickoolcars]

I looked at this vid…… and thought WHY?? ……. But you know not all of us have drug money to throw at cars! And I LOVE the DIY style. Doggy old 6 banger manifolds are bloody agricultural at the best!! So WHY NOT!! Go hard man. I wish you great success.. 👍👍👌

[@pushrodtv6623]

Thanks mate 👍🍻

[@Bigcountry_littlelegs]

Great vid

[@pushrodtv6623]

Thanks mate and thanks for watching🍻👍

[@jakestacey4324]

Good work

[@pushrodtv6623]

Have a look through the play list for the other 2 enstalments thanks for watching👍🍻

[@paulthompson1654]

Best thing u can do if running the water preheat is . The single carb manifold will foul the X2 headers but after market headers probably ok After cutting out the manifold coolant base ,,, found they get full of corrosion / compacted sand If going to use the factory cooling hose setup I would do this .

[@pushrodtv6623]

Thats correct about x2 headers and single carb manifolds ,(i haven't ) but have you tried the later single carb exhuast heated inlet manifold with x2 headers thanks for watching 👍🍻

[@paulthompson1654]

X2 headers hit the water heated manifold , major clearancing involved . . Pace maker extractors will clear the manifold .

[@lesliepotter3553]

Good stuff😂

[@pushrodtv6623]

Thanks for watching bud 👍🍻

[@pauljolly8687]

How much improvement could you expect with such an inefficient manifold design?

[@pushrodtv6623]

I'd say 10hp - 15hp but as with any engine it depends on engine combo but more to the point with this and p2 &p3 videos is about what you can do with little to no money and building on your skill set ,thanks for watching mate 👍🍻

[@marksmith2726]

We have been doing this mod to these single and twin stromy manifolds for years and it works, Idles better and makes more torque and power. Put a 10mm bakerlite spacer under the carby also and it works.

[@pushrodtv6623]

Thanks for commenting and watching👍🍻