They also have the holo powder, you could rub on the tacky resin, then pour over it
@IndiaBradyArt3 жыл бұрын
These are amazing. I like it when you said to let the resin cure for a little bit and then add the film. Thank you for sharing.
@KellyJCalton3 жыл бұрын
Thank you for watching!
@reneetollison80322 жыл бұрын
I use a 12x24 inch floor tile on top of my mats, then level. Both the mat and tile are in a gull-size baking sheet, so it’s easy to level.
@karenkirkwood59663 жыл бұрын
Thank you for the tutorial and guide I’m starting my business an this was very much needed. You put things in a nut shell for me.
@KellyJCalton3 жыл бұрын
Glad it was helpful!
@ChibiChula3 жыл бұрын
I'd maybe fill the molds with 4mls of resin, wait until tacky and then add the strip but make sure to press from the center outwards to prevent trapping air. But they still turned out great! 😁
@KellyJCalton3 жыл бұрын
Thank you for watching! Yep, I learned pressing from the middle is a must!
@jeannette551003 жыл бұрын
beautiful
@michellegulewich9002 Жыл бұрын
is the vinyl sticky side up when placing in the dominos?
@7spiritualcompass7063 жыл бұрын
What kind of resin did you use? They're really stunning.
@kaceeboxers35803 жыл бұрын
Very nice! Thanks for sharing your experimentation. Have you considered using dicro-ish film? I have some but no domino molds. It works good in other molds, either cut to size or cut up in small chips ( pain in the rear to get them small). But a bottom coat of black resin really makes them look like dichroic glass. Little windows on KZbin has some videos showing how to work with it. Now, off to find domino molds 😀
@KellyJCalton3 жыл бұрын
Yes I have but I haven't tried it yet!
@vickyewilliams57643 жыл бұрын
Hey Kelly. Beautiful dominos!! Did you spray the mold with alcohol in the last test?
@JuiseeDaQueen53 жыл бұрын
For the ones that didn't come out quite right with the pieces of vinyl, make a complete set, sand them, clear coat them with a clear spray paint them and sell them
@KellyJCalton3 жыл бұрын
thanks!
@dominoreaction25643 жыл бұрын
@@KellyJCalton Love you, Dominoes! I Like this my dominoes in my Holographic!
@marycasasnovas57102 жыл бұрын
What kind of resin did you use?
@latricephillips90903 жыл бұрын
Amazing! But even if they weren’t I’d subscribe just because you’re from Chicago! ❤️
@KellyJCalton3 жыл бұрын
Thank you!
@lisataylor55353 жыл бұрын
What type of film did you put in the dominoes
@KellyJCalton3 жыл бұрын
It is vinyl and link is in the description.
@trinasmith39793 жыл бұрын
nice
@spiritwings45923 жыл бұрын
When you do this do half the domino. Then put a thin layer of UV Resin then finish off with epoxy.
@KellyJCalton3 жыл бұрын
I haven't had good luck with UV Resin. It always stays sticky for me!