Holzfforma G395 porting and comparison

Рет қаралды 3,071

srcarr52

Күн бұрын

Пікірлер: 26

@BuckYaSaws 2 ай бұрын

That’s pretty cool to teach your friend’s son about engines!

@cajun3197 2 жыл бұрын

Man you build about the meanest 395s I’ve ever seen!

@DaveyBlue32 Жыл бұрын

Hey Cajun, really appreciate the link from your video and your recommendation to come and see a damn strong 395 that SCarr’s built! That’s a 28” Rollomatic and it’s an 8pin…? Dang it man! She’s rippin’ chip!!! Really appreciate that duration information because I have found an extra cylinder and I’ve got to do some work on mine eventually! Great Video!

@JandSChainsaw 2 жыл бұрын

👍👍👍I bought the kit saw didn't have the piston issue it fit well

@Houseworksaws 2 жыл бұрын

Man I really like that hand piece I ordered of yours. It’s kick especially for the small cylinders

@srcarr52 2 жыл бұрын

Awesome. That’s great to hear.

@steppoffaith8426 2 жыл бұрын

That tables exallent!!

@jarrodskeete52 5 ай бұрын

Hi Shaun, curious where these ported 395's tune to.....i know reading the plug is a safe tell but in general are you tuning to between 13 500 and 13800 on these one good and hot?

@enednas801 2 ай бұрын

Im in need of a 70-90cc saw to buck a big maple trunk for firewood and been looking for a Holtsfforma 90cc stihl or husky clone and now im here xD im not sure if I wanna risk having to fix the damn thing more than I use it but oem husky and stihl that big are expensive :O

@cajun3197 2 жыл бұрын

Pretty much was my thoughts on the 288 farmertec cylinder. Without machine work and no gasket the FT288 cylinder intake was 154 duration. They definitely don’t need a bunch of machine work to make decent runners. Great video Shaun! Is important for people getting into this hobby to start realizing that porting all cylinders or saws isn’t exactly the same. It’s about optimizing what you have to work with and everyone has their own way of doing this. 👍🏽👍🏽👍🏽😁

@DaveyBlue32 Жыл бұрын

Is a 661 piston a little taller from the pin so you could cut the squish and do that piston swap??? Those Duke’s little moly pistons are remarkably good quality for the $27 or under $30 bucks apiece for whatever model saw’s your doing…I’ve been using a couple of those in different build’s and have been super stoked with their performance! You must have some freaking awesome compression with the 50 thou cut from the band! Dang near 190? That’s a fantastic build on the clone and it’s a ripper… but that OEM saw’s just straight singing and blasting chips!!! Your selling a handpiece that will run on the Foredom’s???

@srcarr52 Жыл бұрын

I wouldn't bother with a 661 piston as they have the ring pins in a terrible location. I've been really happy with the Duke's pistons. Compression on these is around 215psi. Check out my other videos for stroked 394/5's that really throw the chips! Yes, the handpieces will work on a Foredom or any other key drive flex shaft motors.