By far the best of the 14 videos I've watched on wire clamps! 🤩 👍
@anonymoususer63343 жыл бұрын
By far the most efficient tool design for this purpose. Excellent job. TY
@WalkOverHotCoal3 жыл бұрын
This is a very good design. Simple and effective. What I learned from this video is something I could never imagine...how to make the loops. When I used my own homemade clamp-tite tool, I wasted a lot of wire as I had trouble figure out how much is needed to complete the loops. This video depicts how to make the initial loops, then doubled up and slipped them over the host object. Brilliant idea. Thank you very much.
@jcarlosSi3 жыл бұрын
Thank you very much for your comment.
@ang82823 жыл бұрын
by far the best explained video i had made one a month ago and couldnt figure out how to make the clamp i thought i screwed up till this video thank you!!
@jcarlosSi3 жыл бұрын
Thank you.
@kerrygibbs81982 жыл бұрын
Very cool, I liked your video.
@nrgsmrt15 жыл бұрын
JS, [ "How To Make The Clamp." ] You genius! Thank you for making this video so much. Tim. ( - :
@jcarlosSi5 жыл бұрын
Thank you for watching this video.
@ngovinhtuong3 жыл бұрын
Cut the tool too short, so dificult to work with it.
@peterclark62902 жыл бұрын
The initial setup of the wire is a prussic knot - save yourself a few minutes: bend the wire in the middle, hold bend close to the hose on top, bring both wires ends under and through the bend twice then pull up, dress the initial setup - ready to go.
@jcarlosSi2 жыл бұрын
If the wire is very stiff or hard it is very difficult to do so.
@ryanb18744 жыл бұрын
Cool. But would be nice to have leveraging tool inclooded
@jcarlosSi4 жыл бұрын
yes, thinking later, you have to leave the iron handle a little longer.
@artteacher.26943 жыл бұрын
👍👏👏👏👏👏👍
@franciscosalamanca81743 жыл бұрын
🇪🇨👍🏻
@jcarlosSi3 жыл бұрын
Lo tienes en español, también. Un saludo. kzbin.info/www/bejne/iX-lpYKghN6NipY