Honda 300L Tail Tidy! 2021+

[@swampfoxmoto5959]

No trimming of any plastics or modifications, all original plastics are easily put back on.

[@justinnapper1042]

Thank you I was just trying to fit mine on and was having issues, took a break went to KZbin and found your video thanks man 🤟😊😎

[@swampfoxmoto5959]

Very cool! Thanks for the comment!

[@WanderingDad]

I used a piece of scrap aluminum and a bunch of tools to make mine, but I'm switching to this. It looks so much better.

[@nachosanz3478]

Thanks, very usefull video. Could you explain how you managed to pass the original light cable through the mid hole?

[@nachosanz3478]

Cant find the way to deassamble the connector so that the wire can go through

[@swampfoxmoto5959]

I cut a flat notch on the top a notch big enough, so the wire would just drop in the hole, with a dremel.

[@zevkej]

Bro you earned a sub and a comment for that. Thanks been looking for one and all the $75 ones they got suck.

[@swampfoxmoto5959]

With the little slab of rubber making up the difference for the hole depth, and a slit for the wire to go through it really levels it out and seals the seat back, the Bolts are a a little longer than the originals but they are the standard metric thread pitch.

[@RickDealz]

How did you wire the License plate light?

[@swampfoxmoto5959]

I used the factory setup just notched the tidy where the light bolts up so i could run the factory wire without taking it apart.

[@2wheels.are.better.than4]

Nice video. Kemimoto products are legit. Their tail bag and gloves are quality as well.

[@robintack2284]

Great video! Excellent explanation.

[@swampfoxmoto5959]

Thank you so much! I try to do videos that are not what I call youtube vomit; just content for content, so my videos are spread out. It is so cool to get positive comments you have no idea how much we appreciate positive people!

[@someguy5035]

Same one I got. It sucks. Mine wasn't square at all. I had to shim it with washers to get it even remotely centered. The tightening method is crazy too...captured nuts *and* threaded holes. You can't really get the nuts tight. The wires were super brittle. They broke twice when I was trying to connect the LED to the power wires. How did you get the reflectors on? The shanks were so short I couldn't get the nuts to bite. I actually cut mine down so it would fit flush against the body. I just used a dremel with a cut off wheel.

[@swampfoxmoto5959]

I did not use washers and barely got them to bite “reflectors”. Everything else goes with the universal fit territory. You have to make it fit. I Cut a slot so the led wires would lay in hole and bolted in the leds.

[@someguy5035]

@@swampfoxmoto5959 I cut a little channel for the wire as well.

[@swampfoxmoto5959]

Brilliant minds think alike!

[@ColinPopoviciu]

great video man. is the rack compatible with the 300 Rally also? do you have a link for it? thanks

[@swampfoxmoto5959]

The rack is from bikerbitz I believe it works on both.