Honda NHX110 Valve check/adjustment

[@Winthrop787]

Thanks for putting this together @DaBinChe. Mine hadn't been done since new (just picked it up), hadn't done valves before but this was straightforward along with the Honda factory service manual I found on Google.

[@rixerman]

Thanks for the great video. When you are at TDC, can you adjust the intake and exhaust valves at the same time?

[@DaBinChe]

yes, but only at the top of the compression stroke if memory is correct. What you have to watch for is the decompression which will cause a too tight a reading. This is why I do it my way.

[@rixerman]

I had a clicking sound after the riding the scooter when the engine was warm. I tried to adjust the valves as some people online were saying that could the cause. The exhaust value seemed a little tight so I adjusted to spec. Now the scooter idles very rough. Any advice you can give.

[@DaBinChe]

@@rixerman check it again. Do it when engine is cold, parked over night

[@netmoemail]

IN 0.16 ± 0.02 mm (0.006 ± 0.001 in) EX 0.25 ± 0.02 mm (0.010 ± 0.001 in)

[@DaBinChe]

+soks yup!

[@Seech1000]

Thanks. If you ever decide to show how to get to the piston rings and check on their gaps, would be great. My scooter loses oil on a constant basis (no leaks) and I have no idea why. Maybe piston ring gaps on wrong side.

[@ikushsm0ker]

Thanks! All your uploads have helped me so much with both my NHX110 and SH150. You thinking about doing one for the 110 fork seals?

[@ikushsm0ker]

Also, How long do think it would take to replace the "53219-GFM-970 STEM SUB-ASSY., STEERING"? Thanks again DBC!

[@DaBinChe]

Gpt Tbone Not sure but that actual part should be very fast, 5-10minutes. What will take longer is getting all the stuff on the handle bar off/on

[@DaBinChe]

Gpt Tbone I won't touch the fork seal unless they need replacing, but will change out the fork oil again and a video on that. Motion Pro makes a fork seal cleaner called SealMate, this is what I use and it works really well.

[@giorgosmakridakhs9733]

Honda lead mondel 2004 Valve adjustment values ​​with filler can you say thank you

[@E8ibrahim]

Hi my friend, I've been watching you for 5 yrs, I have owned a Honda lead since then I always follow ur vids, but today I'm facing a new problem, basically I wanted to adjust the valves level and I found out that the (rocker) stuck on the end of the valves even when the adjustment nail is lose, any idea of why this happened?

[@DaBinChe]

look at your cam lobe it needs to be pointing towards the piston not away from the piston

[@E8ibrahim]

@@DaBinChe I checked and it turns out the valve cap is melted somehow I ended up replacing them and now at the moment am adjusting the valves after 1 day of use in the new valves

[@DaBinChe]

@@E8ibrahim WTH? low on oil maybe? These things consume oil. I top mine off every 500miles. Make sure you check oil level correctly with the oil cap/dipstick not screwed in. I have a video on that.

[@Q8offroad]

Hay... Can You Plz Make An Video For Tuning Carburator....

[@DaBinChe]

+anas rakhda the NHX110 doesn't have a carb, it is FI