HONDA TRX450ER ENGINE TEARDOWN- PART 1

[@knallerttuning-dk9666]

hotrods dont last. i had one, only ran 25 hrs before it snaped

[@nimwit0]

Had a hotrod in mine for the last 4 years.

[@nimwit0]

Rev limiter all the time, well over 80 hours on it.

[@schons77iceman]

I literally just got done doing the same thing to my 07 trx450er and I went with OEM honda crank and OEM piston and cylinder because I didn't hear good things about the hot rods cranks but never the less awesome video

[@motion_mx]

Nice dude! The best way is OEM 100%. I did this build for someone else. I hear best way to bring reliable power is OEM bottom, stock piston size, hotcam, port job, and a JD jet kit. Should be golden.

[@tomatoknuckles]

Just watched all your vids and just wanna say it's great content, but it would be nice to see the finished bikes.

[@motion_mx]

Appretiate the feedback! I am working on a bunch of new videos to post soon.

[@machito9477]

Everyone forgets recording splitting the case part

[@hunterdelozier-k5u]

Loved this video! I have a huge respect would you want to rebuilt my 2009 trx 450er for a video and i could pay you ?

[@motion_mx]

Message me on Instagram @motionmx_

[@christianyoshida2755]

Do I need to pull the engine out just to replace the clutch side case. I picked up an 05 and it’s cracked by the kick starter

[@motion_mx]

Nope! You may need to remove the brake so you can remove the case though. Go to my channel and look for a video called "HONDA TRX450ER COMPLETE RESTORATION! FIRST START- PART 3" and go to minute 8 of the video..dont forget to subscribe if you haven't already ;) Thanks!

[@habra562]

Hey Mine needs the left engine case replaced how much you think is fair for me to pay iam in socal

[@motion_mx]

Left case is $327 on Rocky Mountain. Since the engine will split I would replace at least the crank bearings while you’re in there. Personally I would also replace the tranny bearings, all new seals and gasket throughout the engine, and new timing chain, valve seals...maybe even a fresh piston and rings. Shop can charge anywhere $450 and up for the labor…probably more depending who you go to plus parts. So I’d say this could be $800-$1200 project

[@famloca7755]

Hey how are u will like to txt you to ask you more stuff about quad I have one but I want to rebuild it so if u can txt me so we can talk cool thank from az

[@motion_mx]

Message me on instagram @motionmx_