How the 37mm shells are made

[@BlazeTechIndustries]

Alternative chamber design amd more available at: launcherpope.com

[@PrintGunner]

Very good tutorial! Although id recommend screwing the grub screw last as a safety precaution

[@LoremIpsum1970]

Congrats, nice video! Any pointers/links to the alternative design?

[@BlazeTechIndustries]

Yes! Pinned comment

[@LoremIpsum1970]

@@BlazeTechIndustries Great, thanks. Name rings a bell from Grogs forum...

[@popinmo]

didnt know the pop can was required it literally doesn't say in the awcy to put it it only says it for the reloading manual which implies its only necessary when reloading

[@markworden9169]

Deep socket

[@Kycirion]

I agree with you on the 8.8 v 10.9 bolt... I tried a 10.9 and burned up 3 drill bits doing the side ports. Definately go with 8.8. I've been curious about the MILC 2.0 inserts. But man, $30/per is way too much.

[@BlazeTechIndustries]

For me it beats the hell out of trying to use a drill press that dosent drill true

[@RemoteCamper]

I used to mess around like this too. Then I found a seller on gunbroker that sells 37mm shells that are designed to hold a 380 blank.

[@poshweevil2960]

26.5mm Is becoming hard come by and very expensive id love to see this scaled down

[@BlazeTechIndustries]

You can make 3d printed 26.5 mm ammunition!

[@nanovox9418]

Less than a 1000 subscribers and over a 100000 views on a short that's shameful.

[@nanovox9418]

Subbed >-