Learn how to adjust your DAS bow's tiller and weight. This straightforward guide walks you through the steps to expertly adjust your DAS bow. Shown on a HT-21 riser, but applies to all Dalaa risers as well.
Пікірлер: 9
@greenhoodedvigilante4583 жыл бұрын
Is the method same on an ILF bow? If it is, make a video for ILF.
@3RiversArchery2 жыл бұрын
The steps are the same for an ILF bow. We are still planning to make a video highlighting on an ILF riser though.
@MONKLJ2 жыл бұрын
Video Tiller on all shooting styles, Split Finger, Three Finger, String Walking , etc Be more explicit Please !! I only shoot Split Finger Only !!!
@josephtreadlightly5686 Жыл бұрын
I've tinkered with my ILF bow. I've used the same steps u have used here in this video & there was little to no instructions given with the new products I have bought. Adjusting the tiller affects your nocking point so someone needs to pay attention to the nock on your string & the tune of your bow related to your arrow. I shoot spilt-finger & after breaking in my new string your tiller measurements will change & I found once this happens that I'm @ a positive 1 or 2 tiller on my bow. However I have another identical string I'm going to break in. With the same bow I'm going to be shooting 2 different arrows off 2 different strings until I eventually settle on one arrow. It turns out that both arrows have a different plastic nock on them. With the 1st arrow I had to add some thin BCY serving material to my string to have a tight nocking point. U don't want to dry fire your bow by shooting the same string with 2 different plastic nocks. When I find a plastic nock that fits & I know which one I now need I will have both strings setup the same. When I achieve that I will probably be somewhere around a positive 1 to 2 tiller with a bottom limb tiller measurement somewhere in the 1/8 to 1/4 inch range less than the top tiller measurement due to my split-finger style.
@Jenna_Tailia11 ай бұрын
Back what @ 6.49 into the video? You saidd to back "UNKNOWN" the set screws when yadyuadyyahh . If I was more familiar with all this excitement from a new found hobby Im currently Exploring into,I would I understand what exactly your referring to. So please forgive my ignorance.
@3RiversArchery11 ай бұрын
For most adjustable tiller bows they have a "set screw" that locks the tiller bolt in place. The comment in the video is a reminder to loosen the set screw before adjusting the bolt and to tighten it back down when done. As it keeps the bolt from moving.
@juliansyjuco96952 жыл бұрын
Very informative video! Thank you for this!
@replicante5799 Жыл бұрын
I am new to this, could you tell me for the string walking what measurement in cm should I put on the upper and lower blades?
@3RiversArchery Жыл бұрын
This will require a fair bit of tuning to get it right for your shooting style and set up. You're best to start at a Zero Tiller (both the same) and adjusting by the millimeter from there. Normally it will end with the lower plate moved in half a centimeter or more, but will come down to your shooting what it will need to be.