Рет қаралды 4,738
Best struggle free method of applying decals to any motorcycle tank .Step by step in close up detail .
The method used in this video is coined as the "Hinge Method" . Typically used on larger decals that could be difficult to land wrinkle free due to their sheer size or the need to form over compound curved surfaces. It is usually a good idea to apply decals over paint that has been clear coated first,
although as seen in this video ,decent results can be had without a clear coat layer . Most decals can be clear coated after application but always refer to the decal manufacturers recommendations to be absolutely certain. Any creases or wrinkles occurring during the application process are usually not repairable so it is very important to be patient and mindful during the procedure ,espesially on compound curved surfaces . Warming the decal and keeping the transfer paper wet while gently coaxing and forming the decal are key factors to success. Always be sure to push air bubbles and water away from the center of the decal to the outer edges as you go . After removing the top transfer paper , if there are any small air bubbles ,they can be flattened out by puncturing them with the tip of a needle and releasing the trapped air . As with most any job the ability to apply decals properly gets easier with experience. But with decals, the unfortunate part is that mistakes are typically quite noticable so take your time, learn from the pros and finesse your way to success.
Good luck , and remember ...Always " TRy'an Lean to be your bikes best mechanic "