How to automate choke lever on gas engines.

This 12v linear actuator is perfect for the automatic operation of the Choke lever on gas engines during startup.
Very easy to install.
Visit us at www.dcautogen.com for more information.

[@ctainc1]

That is amazing! Thank you for this video! I have purchased a 30mm 12v Actuator, and the switch. Will be installing tomorrow.

[@DCAutogen]

Glad it helped

[@davidwhitlock5832]

Looking to see how it is wired and part number of the linear actuator thanks

[@ShiqPeachez]

How do I connect the chock to a v7 controller

[@adeyemibabatunde1814]

Well done, which motor, wiring diagram and mehanism are used?

[@DCAutogen]

Available in the video description.

[@wildncrazyguytv]

How would this weather saltwater environments? I have the GX390 on a flounder boat. The boat runs in the bays and I live near the coast and my boat stays outside. Thank you!

[@DCAutogen]

Not that well. Anything subjected to high humidity with salt water will eventually be affected.

[@wildncrazyguytv]

@@DCAutogen Thank you. I would love to have one, but I would hate to have problems when I’m out. We have harsh salt conditions out here and the motor is always outside.

[@DCAutogen]

@@wildncrazyguytv totally understandable. If you are referring only to the Choke Linear Actuator, I can only suggest it be opened up and covered with grease to avoid deteriorating by oxidation. In regards to AutoGen controller, this can be housed in a weatherproof enclosure away from outside elements.

[@edburie5621]

Is your website down? I'm getting this error message "Connection denied by IP2Location Country Blocker" I'm in the USA

[@DCAutogen]

Hi. No its not down. We are blocking China, Russia and Ukraine due to a high volume of attacks on the site the last few months.

[@user-tp5hq1zx9c]

how did you wire t he actuator

[@DCAutogen]

It has 3 wires. Red is constant +12vdc Black is Ground. Green is the trigger. When the trigger is pulled to Ground, the actuator extends and when released it with tracks. Green is connected to pin#5 of AutoGen.

[@rjoutdoors2270]

How do you wire this up?

[@DCAutogen]

Powered by a constant 12vdc(starter battery) and the trigger wire is grounded. Comes prewired with a dpdt relay and is activated by AutoGen controller during startup. The actuator has internal limit switches.

[@rjoutdoors2270]

@@DCAutogen so it automatically retracts after it cranks?

[@DCAutogen]

@@rjoutdoors2270 yes

[@gmsgabaradama2009]

What model where do I buy?

[@ShiqPeachez]

How do I connect the choke to v7 controller

[@ShiqPeachez]

How do I connect the choke to v7 controller

[@DCAutogen]

Wiring diagram is available on the products page. Red wire is +12vdc Black wire is Ground Green wire is the trigger. Connect directly to pin#5 of V7 AutoGen as per wiring diagram. You don't need a relay on pin#5