How to Bind and Setup a Car on the RadioMaster MT12

Have questions about the MT12? Need help with a setup? Comment down below if I didn't answer your question in this video. Don't forget to subscribe and like the video!
Checkout our store here
www.buddyrc.co...
Buy the RadioMaster MT12 here
www.buddyrc.co...
Buy the ER5C ELRS rx here
www.buddyrc.co...
Buy the WOV Racing cars here
www.buddyrc.co...
The RadioMaster MT12 represents a groundbreaking open-source surface radio, and it holds the distinction of being the first surface radio to receive official support from EdgeTX, ExpressLRS, and the Multi-module project. With its impressive 10 physical inputs and the ability to accommodate either 16 or 32 channels*, the MT12 is perfectly suited for a diverse range of surface models, spanning from automobiles and trucks to watercraft and more. With its extensive customization options and adaptable operating system, the MT12 distinguishes itself as an exceptionally configurable surface radio, ready to perform exceptionally in a wide range of situations.
Available with built-in ExpressLRS or 4in1 MPM RF modules
Featuring a powerful STM32F407VGT6 with 1MB Flash
Preinstalled EdgeTX firmware
QC3.0 fast charging supporting 2.0A MAX
Compact design with excellent ergonomics
Oversized battery compartment - 2 x 18650 cells or a 2s 7.4v 5000mah battery pack (Batteries not included)
Standard Nano module compartment
RadioMaster standardized button layout
Rotatable antenna
Customizable base switches or 4 way joystick included

[@emptyqrider]

Incredible helpful video 👏🏻👏🏻👏🏻 follow you and thumbs up always.. i just started using this radio .. overwhelming features yet facing some issues while binding my aarma blx mojave .. i don’t know why do Ch5 interference with the throttle.. i will check .. also if there is a way to reset the radio ?

[@lexingtonbecker6723]

Just picked up one of these and this was an excellent primer. Thanks!

[@matthewh6242]

For racing which version would be better?

[@BuddyRC]

Thanks for watching! I use the ELRS version to race with because it has the least amount of latency.

[@bsr3280]

Just getting a green light flashing. Express LRS receiver to traxxas ESC lower the Packet rate 50Hz 115dB Or it may not work.

[@bigskyrcguy]

Super informative and very well done. First time watching and new subscriber. Thanks bud!

[@shuster1921]

Thanks for the help, clear and easy to understand, new sub,,,

[@TonyBaumann-q2d]

First time watcher. Thanks for the video. Straight to the point and valuable content. Takes watching 8 other peoples videos and being confused or this video that gets you where you need to be. Thanks again m8

[@natyvia]

Thinking about getting one for my crawlers. Can you do a video showing how to setup for dig and a 2speed transmission

[@TruckingWithSteffon]

so I just set up a nitro car and i just used the weight, offset for throttle and and break and steering i just adjusted the weight and it was all good. did i do it wrong? didn't need to reverse any servos.

[@jooonsRC]

New sub, cheers from South Africa

[@scottiequick]

Awesome radio

[@SentinelGames]

What are the chances of a custom branch of Edge-Tx being developed for this radio? One that's a bit more intuitive and efficient to set up a car.

[@BuddyRC]

Thanks for watching! I hope so this would open up this radio to car people a lot more. The cool part is its all open source so it could happen at any time now if someone can put in the work.

[@SentinelGames]

@@BuddyRC I hope so too as I'm intrigued by this radio but I can't tolerate the GUI. It needs to be simple, fast and precise.

[@ramoncruz1725]

Hi I been trying to bind my granite grom to my mt12 had no look ?

[@BuddyRC]

Thanks for watching! I'm not familiar with the protocol used on that model.

[@salvatorecondina2898]

Pas mal du tout très bonne explication félicitations

[@optimuscrime608]

Hey sir I’m looking for the best controller I can get for my Traxxas XRT. Any suggestions? Let me know what to get an post the link I’ll grab one from ya if you got it! Thanks man

[@BuddyRC]

Thanks for watching! The MT12 4 in 1 would probably be best for what you want.

[@isrz8740]

So the 4-1 can bind in any receiver?

[@BuddyRC]

Thanks for watching! The MT-12 will work with the following Futaba S-FHSS, Walkera DEVO, DSMR, DSM2, DSMX, Flysky, Frsky, WLToys, Hubsan, Hisky, Esky ,kyosho, Assan etc.

[@everettpace4687]

What type is the wov truck

[@BuddyRC]

Thanks for watching! It unfortunately is its own protocol I tried to bind it but had no luck. So I put a ELRS receiver in it.

[@everettpace4687]

@@BuddyRC absolutely you guys have a couple good rigs I have the truck I do plan on getting the other one