How To Build a Vise Stand - See How To Make a Mobile Vise

Welcome back to my chanel!
Today I will show you a video How To Build a Vise Stand . You may read the description of the video for further information in that topic.
In the previous video available on the channel, I renovated an old vise brought from a scrapyard. The vice did not have a stand, so I decided to make a new stand from what I had at hand. The entire vise and stand must take as little transport space as possible meanwhile it has to meet the requirements of a mobile vise. Judge for yourself.
I hope that the video with the portable vise will be enjoyable.
If you like the video then feel free to leave a like , subscribe and if you have any questions or any suggestions then comment down below.

[@maverick4053]

An awesome video as always!

[@pureexpanse]

Thank you.

[@dapper2983]

Good job👊

[@pureexpanse]

Thanks

[@DonDomel]

brak słów ! normlanie bajka !

[@pureexpanse]

Dzięki😉

[@metalowehobby]

Bardzo ładnie wyszło!

[@pureexpanse]

Dzięki

[@bigmonster1524]

👍👍👍

[@ZygmuntKiliszewski]

Porządny koncept i precyzyjne wykonanie. Najbardziej lubię oglądać Pańską pracę podczas cięcia szlifierką kątową i spawania TIG - giem. Ten uchwyt/imadło do rur ma teraz solidny stojak. Gratuluję i serdecznie pozdrawiam 😀. Odpowiedziałem PatHudgins na jego pytanie. Ciekawi mnie, czy uruchomił motor? Dał mi suba, chyba ją zaakceptował?

[@pureexpanse]

Dziękuję bardzo. Wiedziałem gdzie go wysłać😉

[@ZygmuntKiliszewski]

@@pureexpanse Tym bardziej pozdrawiam 😀.

[@pascalrhins3770]

Awesome job, sir ! A lot of engineering inside... it might be a silly question, but what is the reason you installed the vice at an angle ?

[@pureexpanse]

Thank you. While looking at other racks and once making a similar structure I made a vice to be adjusted. The tilt corner gives you more stability and the use of more pressure when tightening the screws.