How To Calculate ESP of Duct Using "ASHRAE FITTING DATA BASE"

[@jorgealcazar6513]

This is so useful. Thanks for this video- Greetings from Colombia

[@pengsiongteoh2782]

Hi, thanks for the video! May i request for the link to the software? Thanks in advance!

[@passionateengineer04]

please check video description Thank you

[@funtimemathswithar1029]

Very informative videos.Thanks for sharing ur knowledge. Can u kindly share Esp excel sheet .

[@passionateengineer04]

Please check the video description

[@LITTLEALADDIN]

THANK YOU

[@johnphilip7084]

Hi dear for shoe neck side for duct branh how canculate n data base which fitting

[@passionateengineer04]

Check transitions

[@elangz9201]

Is there any way we can view the tabular value of the fittings from the software? I couldnt find the pdf versions of various fitting values presented in tables. (the ones i found is not as complete as the ones in the ashrae dfdb software) also, i didnt see the link to download it. Are you using the original one or the cracked version. Thanks in advance!

[@passionateengineer04]

These all values are available in ASHRAE handbook. This software is not crack one.

[@DuraiSathya-m7m]

Thanks a lot. Please share the software link

[@passionateengineer04]

please check video description Thank you

[@algalis55]

I noticed that for transition you only add the largest size (width) and ignore the other (small one) & Even though there is `from fan` symbol on the template, you calculate it the other way around. how does the program consider and calculate it?

[@passionateengineer04]

Please watch it again, i have already put the small and large side values, the fan is not a part of ESP calculation. Equipment is a part of total static pressure.

[@algalis55]

@@passionateengineer04 you misunderstood my question. when you calculate the first transition, you did not enter 24" (width) anywhere. you only entered the heights and width of the one of ducts.

[@mercychoge9994]

I have a question the translation should have different hight size , coz am trying with the some size then boom an error

[@passionateengineer04]

Transition have two different sizes smaller and bigger

[@mepDesign-q8u]

You didn’t consider grille pressure drop that will come around 10-20 pa

[@igoralves4484]

i can`t calculate the pressure loss, the software shows the message "possible input error" do you know how to fix it?

[@passionateengineer04]

Run as administrator.

[@deleodelola9960]

tanx a lot for this piece

[@nishadn4636]

can u please share the link to download the software

[@passionateengineer04]

Share your email, i will send you.

[@abdulrahimanshaikh5521]

how to change unit in ip to si in software

[@passionateengineer04]

You can download the SI version.

[@mercychoge9994]

Click on Utilities a small dialogue box(preferences)will appear, then click on units

[@sajeeshn7163]

please share the Ashre data base link

[@passionateengineer04]

please check video description Thank you

[@tezeswars7052]

Can you share me where to download this for laptop

[@passionateengineer04]

I will upload it on my website and will share link soon. Thank you

[@tezeswars7052]

Please share thank u@@passionateengineer04

[@3099saaz1]

Why you are wasting time in converting mm to inches go to setting n units and change it ...........................

[@aaqibnazir536]

Pathetic, max time used in converting mm to inches.

[@passionateengineer04]

Can you please elaborate?

[@keralatalkz6354]

could you please share the link of this software?

[@passionateengineer04]

Ok i will share