How to Change Radiator | FIX Overheating on Mercedes ML GL W164 X164 W251 | MrCarMAN

[@alikelystory7151]

exceptional video. perfect coverage and great use of FF to properly time-lapse it

[@MrCARman]

Thank you! I’m very happy it helped Thank you for liking and subscribing, I really appreciate it

[@therealeffingdeal]

Your knowledge is paying dividends 5 years into the future. Thank you very much for this. Though i needed to remove the bumper to get access. Now I know I dont have to.

[@dhunt873]

Good job on the video but there was a few key steps that was not included such as the proper way to take off the transmission fluid lines. Also you skip the step to remove the last screws from the radiator on the lower driver's side. After looking at the video a few times I notice the other person assisting you pointed down when you first tried to lift the radiator and it would not come out. While I appreciated the attempt to complete the video in at a rapid pace, those small details cause me a few a little extra time when I remove my radiator using this video as my guide. Including those would have made the job easier. Thanks

[@MrCARman]

Hi, I really appreciate the honest feedback. It was very hard making a video on this and it was all trial and error. No one really makes any detailed videos on diy for Mercedes Benz especially the w164/x164 SUVs. It’s a very tight spot and hard to get the camera for a lot of things but I gave it my best to help others out

[@paulchambre6771]

I did this job on a 2006 ML350. I did not have the small oil cooler in front that was shown in the video. Instead there is a cylinder shaped cooler or something. There were actually three harder to get to bolts. Two at the front sides, near the bottom, hold the lower part of the shroud to the radiator. The other one, at the bottom of the driver side of the radiator holds a line block from that cylinder to the radiator. For the front shroud bolts, I found that I could reach around and under to get to them with a ratchet (air ratchet, in this case) after disconnecting everything else, popping the radiator up out of the lower grommets, and pushing it back (to make a gap between the front shroud and the back of the bumper cover). The bolt that holds the line block can just be seen from underneath behind the Torx bolt that holds the bottom end of the windshield washer reservoir. I was able to remove that with a ratchet wrench from underneath and behind. Only a tiny range of motion is possible, so it was a lot of one clicks with a finger poked though from the front to keep the bolt moving in only one direction. Putting it back in after replacing the radiator was also a pain. I guess Mercedes designed this setup so they can install the whole assembly (front shroud, condensor, cooler, radiator, and probably the fan and its shroud) as a unit, but it certainly makes for a pain when trying to replace just the radiator.

[@Charles-iy9ik]

Excellent vid-saved me $1100. Thanks!!

[@roberthyde8147]

Good job, nice pace on the video and good tips on the steps.

[@MrCARman]

Hi Robert, thank you! And I’m glad you enjoyed it:)

[@valgin]

Excellent - just blew my radiator on my ML500 2006 - I think I can do this thanks to your video - appreciate it!

[@MrCARman]

Sorry to hear about the blown radiator but I am glad my video helped you Thank you for subscribing to MrCarMAN!🙏🏼

[@mammonclarke]

Thanks. That was really helpful. I need to replace the lower big radiator hose. Do I need to do all of this or can I get to it from underneath?

[@MrCARman]

A smaller/skinnier hand can get it from underneath, otherwise you have to do it like in the video You are very welcome, Thank you for subscribing to the channel and sharing this video with others🙏🏼

[@eliseshie5922]

I love it, I took my to the dealers and they want to charge $2800 to replace and labor, I ordered the radiator online and I'm replacing myself next week

[@MrCARman]

Your welcome, I am really happy this video helped you out Thank you so much for subscribing and sharing the channel, I really appreciate it! Have a blessed day

[@fredb711]

Thanks for taking the time to make this video. Very helpful as I do research on doing this job for a GL350 bluetec. How long do you estimate the job takes. Looked like you finished at night... Also, did you need to top off trans fluid level after the job was completed? I assume yes.

[@jayflores4692]

Hi MrCarMan, I have a couple of questions, did you loose alot of Transmission fluid, I belive these transmissions are sealed and is it true you need to drain the power steering fluid in order to prevent air damaging the steering pump? I need to replace the radiator on my ML350 and it has a 7 speed transmission, thank you for this awesome tutorial.

[@TheRruki]

Nice and easy video smart man thank you you just save me $

[@MrCARman]

Your very welcome Ledi, I’m so happy it helped!! Thank you for sharing the video and subscribing, I really appreciate it!!

[@alfredmelendez6792]

Great video. I need to change the radiator on my 2013 E350. Will this video apply for my vehicle also?

[@MrCARman]

Yes it will, its a very similar method

[@tonyr9140]

Awesome work and always great to see your videos in my feed😁

[@MrCARman]

Thank you for always liking, sharing and being subscribed to the channel:)

[@eliseshie5922]

How do I top up the transmission fluid is there a way to know how much I put in, also when you were removing those line was the ac line affected did you have to refill your ac

[@tomtamshen7277]

The video does not address trans fluid nor breaking ac lines. These are two very costly items that should have been addressed.

[@harpreetsandhu6145]

Very useful video. Thanks for sharing.

[@MrCARman]

Thanks you for ALWAYS liking, sharing and being subscribed to CarMAN! I really appreciate it

[@gilbertpaign1777]

Love the look of the cat bro

[@MrCARman]

Thanks you for ALWAYS liking, sharing and being subscribed to CarMAN! I really appreciate it

[@taher1973]

Thank you. Great video

[@MrCARman]

Glad it helped, and thank you for subscribing to MrCARman!

[@cocobass]

Small block radiator - it just doesn't "small ratchet out". How did you unscrew it with the support still on? Also, the bottom bolts on driver's side that hold the radiator in. How did you remove those without removing the bumper? Any tips on the passenger side bottom large hose clamp - how did you remove it? Decent video but what should take 4 hours winds up taking 8.

[@paulchambre6771]

I posted a reply about this futher up.

[@explorinlearnindoing5462]

@@paulchambre6771 where?...

[@osvaldoguzman5684]

GREAT VIDEO...BTW, what tools do I need for tranny hose removal? any special tool? 07 R500 MB 4matic

[@MrCARman]

Replacing the radiator and fan, this video applies to many different models including Mercedes W203 W204 W210 W211 W220 W209 W164 X164 W251 W221 (C230, C320, C250, C300, C350, E500, E350, S500, S430, ML320, ML350, ML430, ML500, ML550, GL350, GL320, GL450, GL550, R350, R320, R500) AND MANY MORE

[@nygapranks5387]

great work, im addicated to your tutorialsss

[@MrCARman]

Thank you for the feedback! And thank you so much for subscribing to my channel, I really appreciate it!

[@joonajks]

Is this process a 2hr job? Great video!

[@MrCARman]

2-3 Hours

[@MrCARman]

Glad it helped, and thank you for subscribing to MrCARman!

[@joonajks]

Did you screw off the transmission line on the passenger side on the radiator?

[@lenin2780]

Do you need to refill the ac after you finish?? Or is good

[@MrCARman]

Hi Andrew, no I didn’t have to refill the ac. If you follow the steps then you will not be messing with the ac system

[@lenin2780]

Awesome I will try to do it my self my radiator is leaking form the plastic in the side

[@MrCARman]

It’s best to do it ASAP, because mine completely cracked and i had to pull out on the side of the freeway when it had happened. So best to do it before that happens

[@lenin2780]

Yes mine it start with add more coolant then check and on the top of the hose the plastic has a line crack. Put glue and fix it good but now is leaking more from under the other part on the plastic so I order the new radiator and hope I can put it on Saturday Rhanks

[@NomadNav]

Very instructive and detailed video 👍🏽

[@MrCARman]

Thanks you for ALWAYS liking, sharing and being subscribed to CarMAN! I really appreciate it

[@beepreston8885]

Great video and very helpful

[@rickfouke5184]

Video done very well

[@MrCARman]

Thank you, I really appreciate the great comment and glad to help! And thank you for subscribing to the channel and sharing the video!

[@amelselwanes10]

Great job buddy thank you

[@MrCARman]

Glad it helped! Thank u for subscribing to the channel and sharing the video!

[@mariofernandez4068]

I have a 2008 320 cdi. I don’t see how remove a coil that is in very front and it’s not showed in this video. Any suggestion?

[@amelselwanes10]

I have 2011 ML350 4matic, I hear some clicking or clapping comes from the front and I hear it clear when I put the car in N ,Natural’ Any recommendations? Tnx

[@boostedjay4277]

Good video very helpful

[@MrCARman]

Glad it helped! Thank you for liking n subscribing to my channel!

[@robertcrawford6251]

Good job

[@MrCARman]

Ur very welcome! and thank you for liking the video and subscribing to MrCarMAN

[@TB-qk2ym]

What are you doing? You don't have to remove the condenser to get the radiator out of the car?

[@MrRevil3]

That radiator was replaced once before. How do I know? Because you did not show that lower right bolt that needs to be removed by taking the ENTIRE front end off through the wheel wells.

[@nygavlogs754]

good job dude

[@MrCARman]

Thank you for ALWAYS liking, sharing and being subscribed to the channel MrCarMAN! I really appreciate it

[@MrCARman]

How to Change Radiator | FIX Overheating on Mercedes ML GL W164 X164 W251 | MrCarMAN kzbin.info/www/bejne/a56tXpVpZpWmnJI

[@NomadNav]

MrCarMAN 👍🏽

[@TOMRYANLUKE]

TY, God bless you!

[@bhjianchao6637]

🤯🤯🤯awesome man

[@MrCARman]

Thanks you for ALWAYS liking, sharing and being subscribed to CarMAN! I really appreciate it

[@pameladouglas3871]

thank you :)

[@MrCARman]

Your welcome, I am really happy this video helped you out Thank you so much for subscribing and sharing the channel, I really appreciate it! Have a blessed day

[@elijahjohnsons7657]

Wooooaahh nice bro

[@MrCARman]

Thanks you for ALWAYS liking, sharing and being subscribed to CarMAN! I really appreciate it

[@bobsaab2332]

Wasn’t feeling the soundtracks but other video content was great

[@MrCARman]

Thank you for the honest feedback

[@gilbertobernal8738]

I'm going to do your steps i don't want to mess with ac lines

[@lisabrueggemeyer3116]

Awesome

[@MrCARman]

Thanks for liking and subscribing, it really helps out the channel!✅

[@shandragooden1079]

Thank you

[@MrCARman]

Ur very welcome! and thank you for liking the video and subscribing to MrCarMAN

[@jondhami4732]

Good share

[@MrCARman]

Thanks you for ALWAYS liking, sharing and being subscribed to CarMAN! I really appreciate it

[@rainerzufall4671]

No Need to Remove the Front bumper ?

[@MrCARman]

Nope

[@jonathanjones-o5h]

Great

[@wheelowheels4845]

Cool 😎

[@MrCARman]

Thanks you for ALWAYS liking, sharing and being subscribed to CarMAN! I really appreciate it

[@haleycamacho972]

I have no idea what this is

[@MrCARman]

Thanks you for ALWAYS liking, sharing and being subscribed to CarMAN! I really appreciate it

[@luzesteras9819]

Www

[@MrCARman]

Thank you so much for subscribing and sharing the channel, I really appreciate it! Have a blessed day

[@gilbertpaign1777]

Car