How To Check Proper eboard Belt Tension

What does good tension for your belt on your boosted board look like? Check out our video and we'll show you.
Visit our website - www.eboardstuff.com/
Check out our lifetime belts - www.eboardstuff.com/products/...
#eboard #eboardstuff

[@bobfiore8]

This is the best explanation I’ve ever seen on how to know the proper belt tension. Thank you!

[@EatSleepVan]

That's awesome, and was the most trouble I had installing my 107mm Abec's. Initially I had slippage so I tightened them, but then had terrible noise! So had to experiment. This technique will help a lot, thanks!

[@eboardstuff6593]

Stoked to help man!

[@stevenlindgren3314]

Idk if I missed it, but You didn’t really cover how to adjust, what to loosen if it’s too tight. What to tighten up if it’s loose. I’ve got a tight belt and need to know what screws to loosen to make my belt do what you’re talking about.

[@MrThrice1234]

Caught that myself, video useless

[@ali94hn]

That is so loose! I put my belt a little tighter than that even and it still slipped and ripped the belt

[@CWBchannel]

Agreed, seems very loose. I get belt slippage when my tension is set like that

[@ambroisevalet]

boosted board come way tighter - is that why motor bearings fail and shafts wear out?

[@elontusk8018]

No. Motor bearings and shafts unlit fail on the v2 boards that were early production. Later in production they changed the material that the motor shaft was made of and The issue was eliminated.

[@MouseCIick]

so the cover is holding the tension? i am very confuse on how it holds tension. what is holding the tension? all i see is everything sliding in and out.

[@elago98]

The bolts that attach the motor to the mount is what holds the tension

[@alexvasilchuk3601]

Is there any “aftermarket” belts that are more durable

[@CWBchannel]

Yes, Kevlar heavy duty belts on Amazon work great. Got almost 400 miles on a set of the Kevlar belts

[@GokuBlack-qq5vf]

My belts dont want to tighten even if i tighten it , it still stays the same loose. And i barely got the envy

[@Adanacon]

The true method for belt tension is: Measure Center to Center of the axle and motor pulley. For every inch measured add 1/64” of belt deflection

[@raymondbriceno3276]

Na

[@rafaelmendoza7357]

How to tighten? Lol

[@JT-xf9sw]

This is bad advice. Wqy too loose