Want to learn more and or buy an electron powder coating gun, the gun we use everyday? Check out my site at www.powderfinishingequipment.com
@EliRobinson-r4yАй бұрын
Is there a way to contact you? I have a question for you.
@RightNowPowderCoatingАй бұрын
right here works! or email dan@rightnowpowdercoating.com
@JoeMama-ke1fi6 ай бұрын
The skinny plastic electrode cover is easy to break so be careful, probably the fourth or fifth time I removed mine to blow it out the threaded end snapped off inside the electrode and I had to install a whole new electrode assembly. I think I was screwing it on too hard and sheared it off, now I turn the bigger electrode assembly and keep the plastic electrode cover stationary because it's easier to tell how hard you are turning the bigger piece.
@يونس-ط5د7ت3 ай бұрын
How to avoid the problems of non-adhesion of electrostatic powder and the appearance of spots on aluminum
@tricountykustomz6 ай бұрын
Looks alot like the same process as my nordson encore lt unit.
@geezus03675 ай бұрын
I am also using a Nordson Encore Let unit, do not have a Carbon ring on the unit, not sure it is supposed to have one??
@tricountykustomz5 ай бұрын
@geezus0367 the carbon ring I believe is built into the nozzle
@electronpowdercoating6 ай бұрын
best for best
@adamderocco10626 ай бұрын
On the carbon ring when you put it back on there's a little wire sticks out do you stick it through one of them holes or put the carbon ring up against that wire
@RightNowPowderCoating6 ай бұрын
the ring just slides up next to the electrode, flat side.