How to connect and Test Electric Fence wire energizer system Wizord 4i

How to test the workability of Nemtek Electric fence wire energizer system (Wizord 4i- E-WIZ4i/UK #panayo #elv #electricfencewire #electricfencing #nemtek #nigeria #osogbo #installer
And "Step-by-Step Guide: Setting Up and Testing a Wizord 4i Electric Fence Wire Energizer System in Osogbo | Panayo's Nemtek Tutorial"

[@aronndou7924]

Good day my energizer doesnt fully reach good on the fence it leaves one green bar and the alarm is flashing so is the service ..and when i switch it on it first works than after 1 min or 30 sec the energiser makes loud beeping sound continuous but the alarm does not ring...my alarm and services flash when its on and when its off what must i do i tried buying new battery and changed wiring with new an the are no unwanted stuff touching the fence

[@installerpaul]

Check your high-voltage cable, there may be contact between the Life and the earth line

[@olusegunmatthewlawal1845]

You said something that if the battery of the Energizer is down, the board will have problem, I have these issue, what can I do sir

[@installerpaul]

It may have a problem, just recharge the battery and fix it back to the energizer

[@Eben_96]

@@installerpaul how many hours can I always recharge the energizer battery to fully charge it and how long does the battery last?

[@installerpaul]

I said it may have a problem, and if it has reset the Energizer

[@brightemmanuel9651]

Sir my wizard 4 is showing alarm and gate light even when I disconnect the fence line pls what can I do.am an installer.

[@installerpaul]

Check the loop on the energizer