highly recommend a exhaust shroud with a 120mm fan, helps greatly pulling that hot air out and reduces temps greatly, i rigged a ks0 pro shroud with some tape and temps are like 90ish without heatsinks
@KIDZFUNTOYS3 ай бұрын
Wow, super smart!!! thanks
@Jeanjeanlabricole3 ай бұрын
Hi and thank you for the vidéo, I don't get how you lift the miner after you put off the screw cause the power connector avoid it from pulling, did you just "force" it a bit or did you do something différently ???
@KIDZFUNTOYS3 ай бұрын
You have to pull it from the back it’s it’s tight
@RainBitcoins2 ай бұрын
You gently pry it
@LoopingFinder3 ай бұрын
Excellent ! quel chargeur as tu pour l'avalon ?
@enjoypolo2 ай бұрын
My concern is more the noise than the heat (its sold as a heater anyway). Do you think those fans are replaceable with quiter ones? Also, I notice a rattling at medium speed, but not at high speed. Is it dust? Or loose screw? Not sure how best to clean this without damaging. Thanks for sharing this video though!
@jasonkidwell1767Ай бұрын
Which bch pool did you choose?
@weepzАй бұрын
How did you get past the USB-C in opening the case, I found that it was making it difficult to get it off.
@TampaTec3 ай бұрын
Wow 😮
@N1NJAKIDD3 ай бұрын
Just so you know, those chips do not need a heaksink, they are designed to run at those temps, even hotter with no problems. You are opening the device and voiding the warranty for no good reason. Secondly this device is marketed as a heater, so its made for hot exhaust air to be blowing. Device is fine as it is
@jasonludwick13712 ай бұрын
what the link the to heat sinks on amazon? Thanks
@andrewenglish38103 ай бұрын
I am surprised you cannot put noctua fans in it, or find a fan that pushes more air through.
@lagueuxrobertАй бұрын
Check the temperature of the USB wire and 120 volt receptacle. They run very high .
@jasonkidwell17673 ай бұрын
What's the trick to opening the case I'm stuck on the USB plug
@KIDZFUNTOYS3 ай бұрын
@@jasonkidwell1767 it’s tight just pull hard. You won’t break it.