HOW TO DIAGNOSE AND FIX ST225 TRANSMISSION VIBRATION!

FOR ALL YOUR FOCUS ST225 PERFORMANCE REQUIREMENTS PLEASE GIVE THE MJP TEAM A CALL ON:
☎️ 01752 600661
📱07791241417
💰FINANCE AVAILABLE, SUBJECT TO STATUS
🌍[e-mail]
📸INSTAGRAM: 'MJPERFORMANCEPLYMOUTH'
🎬 KZbin: MJ PERFORMANCE
#teammjp #ford #focus #st225 #electricorange #tranamission #vibration #howtoguide #cartutorial #builtnotbought #modifiedfords #fordsofinstagram

[@GCMYT]

Awesome video!!

[@styusuf5671]

Great vid guys, waiting for the day mine decide to play up, had my ST 2 years and they seem fine so far.

[@oblivionmodda]

Hi, just a big thank you for making and sharing these videos! Here in NZ it's not such a common car but I love it and plan to always look after it properly. Your experience and wisdom is much appreciated!!

[@mjperformance8161]

Wesley Readhead Hi Wesley , great to hear you are following us and are liking our vids over there in NZ , many thanks for the positive comments and kind words, keep supporting and take care 💥🔥👍🏁 Best regards Martyn

[@kevingoldbey7401]

Aww man tought I would off seeing ye putting them back into the car

[@monty6545]

Hi guys good channel good content. i had the same trouble on my mk2 focus rs after i put eibach springs on it started vibrating at 50mph under load. i trailed the internet for an answer and came across a possible cause being that the tripod bearings wear a groove in the cup over time and if a car is then lowered the shaft angle is altered and so the bearings can rotate across the groove which gives the vibration, it was really bad. my local garage said they could source ford recon shafts on an exchange basis which was half the cost of new ones. i had not been aware ford did this so i went with recon which was 3 yrs ago and still working fine.

[@amsingh3041]

Good video mate, my local factors sell rebuilt geniune Ford driveshafts, and they are reasonable cost, obviously you need to return the original ones back to them. Do you think they would be suitable?

[@mjperformance8161]

Am Singh Hi Am , I’m not aware of any factors that sell genuine ford reman driveshafts only from Ford but if you can obtain them elsewhere but make sure they are genuine and not another make in a Ford box . Good luck 💥🔥👍🏁

[@amsingh3041]

@@mjperformance8161 definitely geniune as they said you can either leave your original drive shafts and have them reman, or take the replacements that they order in.

[@mjperformance8161]

Am Singh Thanks mate , sounds good , go for it 💥🔥👍🏁

[@Toecutter12]

Just one question, when you say new oe ford are you saying new new, or ford oe remanufactured . Ta

[@shaunwelch9176]

New new from ford. Hope u have a good bank balance

[@petermeter9190]

My driveshafts are changed ( changed two times, to diffrent brands ), vibrations when accelerating, what can it be?????

[@radu225]

engine mounts and gearbox mount were new/good codition? otherwise, the new driveshafts will fail again!

[@albundy6034]

Hi so i have a 2010 focus st3 and it shakes when braking. I have been told as i have had the wheels power coated that because there was excess its putting the wheel out is this correct?

[@ramsdenkeith31]

Could that be cause of a knocking noise I have it only happenes when I move off

[@Roadwarrior92]

Why are they so common to go?

[@funnyjordan1994]

What’s the best springs to run on the oem driveshafts ?

[@trophy182]

Hi guys, is it Castrol syntrans transaxle 75w-90 you use? Is it just 1 litre you need or do you need more?

[@mjperformance8161]

Hi , we use Castrol 75w fully syn FE TransX Ford Spec , you can buy it from Euro Car Parts ok 👍🏻🏁

[@trophy182]

@@mjperformance8161 nice one mate,much appreciated 👊🏻

[@andybrace4983]

yessssssssssssss

[@davecozzie1]

Have you heard of the s9 motorsport driveshafts from dreamscience £650 for pair. Have u used these before n if so what do u think?

[@mjperformance8161]

Please give us a call next week to discuss

[@davecozzie1]

@@mjperformance8161 ok. I have a brandnew set about to put them on the car in the next week or 2

[@carswithsean7967]

Where are you guys based? And how much would this work cost just bought myself an st225 and it shakes like a shitting dog! Pretty sure it’s my driveshafts

[@mjperformance8161]

Hi, we are based in Plymouth. Our contact details are in all the video descriptions and end credits so please give us a call next week and we discuss regarding your ST225

[@carswithsean7967]

@@mjperformance8161 that is absolutely brilliant I’m in south brent so that’s perfect! Thank you for the reply

[@joeyhill9187]

Oem drive shafts are better than any aftermarket..

[@DODIKKE]

I have data on st225 about 500nM twist. floods go hi ...

[@gethinevans1876]

My st225 is shaking when I accelerate, and hear the dashboard shake, would the driveshaft be the culperate?

[@petermeter9190]

Also have this problem, what was it?

[@gethinevans1876]

@@petermeter9190 hi it was defently the drifeshat, I had to replace both.

[@Peter2meter]

I have replaced them, two different types and still the same problem... ?

[@BlackDeath2885]

Volvo C30 drive shafts are better don’t use Ford they are rubbish