How to diagnose ignition coil on leaf blower

This video is in response to a viewer, but I also thought you would like it too. The principle is the same as the push mower I did previously. I show how to determine if the problem is with the kill circuit or the ignition coil as well as how to test the kill switch.

[@connectingdots3574]

It feels like a journey.....surfing and searching for this channel. Perfectly to the point with involving every detail and not making a fuss about it. Excellent job.

[@JoshBourke]

My exact leaf blower there. Replaced carb, spark plug, and am now looking at the electric. Helpful video thank you

[@Dormdad09]

Thanks for doing this video, very helpful!!

[@ninazeng6036]

Nice job!

[@ronchron1658]

I’ve tested ,coil, it is good.kill switch was isolated. Can you suggest something for me to try next.

[@victorcruz8488]

Hey j what's up! That's a great video helps I lot!im not good on the electric stuff ! But have a question! I have a PB 755 it was running fine before I did some work on it, the muffler was loose I keep putting new bolts but didn't help! So I decided weld the muffler so now the blower won't start! I on ready put a new coil still don't run!any idea!!! Thanks!!!

[@ringsidejudge4302]

Good video . I have a stihl 400 blower , when the kill switch is off , I have spark at plug , when it is in the on I still have spark at the plug . It will not start so I think my problem is something similar to what you are explaining . Any ideas on how to rectify it . I am a bit of a dummy when it comes to understanding kill switches . Any help would be very kindly accepted Thanks in advance

[@slimsqde7397]

if you have spark it should run. your switch problem means the switch isn't grounding out, chase wires and check all connections. But your issue of it not running is either carb or compression. make sure you got spark, then spray starting fluid into the intake and if it runs then the problem is the carb and if it doesn't than the problem is compression or an air leak.

[@MissingLinkMTB]

My spade terminal and ground terminal are a dead short... with the wires unhooked from the coil. Dead short internal to my coil :(

[@jimmythompson9394]

You just make it more confusing. It shouldn't be that difficult

[@ninazeng6036]

【from HIPA】Would you like to test my parts for your equipments?thanks