How to disassemble ES2 scooter Internal battery without explosion

This video shows how to disassemble the battery, be careful and fully discharge the battery before starting any disassembly
Links:
Ebay: ebay.us/yGG2tb
Amazon: amzn.to/3MCHtqV
Aliexpress: s.click.aliexpress.com/e/_DFG...

[@AbdAlgani1999]

thank you i really wanted to know how to open it to replace the cells

[@RoeeBloch]

good luck, and becarefull

[@KinariCuzz]

Cant I charge them while they are connected to the rail? As long as I keep the pos/neg orientation?

[@HuskyAbroad]

Do you know what a flashing red light means

[@savioesse]

Hi mate, how do you actually remove it from the post. I took out all screws, but looks like I need to turn it until the dents are matching, but is stuck

[@OldBillOverHill]

I hear there is a screw at one end of the rod. Probably the one with the white glue. I just tore one down by cutting the rod and sliding the 4 cell assemblies off. I wish I could find the schematics for the entire assembly. I hate having to reverse engineer this stuff. Try this forum, I think I'll join it. secondlifestorage.com/celldatabase.php?fkeys=lg&fbrand=&fform=&fmincap=&fsort=1

[@Smith.S.sStocHasticSs]

I'm removing screws rn.

[@MahiEurope]

Can i install this battery into ninebot e25e??

[@noureddineselmi7277]

Hi I apologize for the inconvenience regarding the evo ccl 5.2 scooter The engine runs normally in empty position 1st and 2nd gear. But when starting in the load position, the current disappeared completely. Where is the problem?

[@Mr.P539]

Hi, is the extra battery NEB1001-U1 is compatible to ES2?

[@RoeeBloch]

no it is written Internal battery

[@Boz1211111]

Bms works when reconnected? Many power tools bms locks when disconnected so you cannot repack batteries

[@derpherpp]

Is this goes with ryobi batteries? I replaced with some scooter batteries 18650 and it’s won’t charges but my dewalt repacked batteries works fine

[@Boz1211111]

@@derpherpp highly likely to happen on modern branded tool batteries. havent worked with ryobi though

[@adnanxm]

Is there a schematic for the BMS or wires?

[@RoeeBloch]

I don't have - but this is simple, follow connections, just need to know where each cell has a tap for connection

[@S1mran..]

Does the pack have bms

[@RoeeBloch]

sure it does!! - otherwise it is very dangerous

[@honkers009]

How do you remove battery from scooter, very few videos show this.

[@derpherpp]

So how did u ended up remove the cells. I haven’t charge my scooters batteries in a while and they’re all dead with no blinking light and one have red blinking light. I think I need to repack them

[@RoeeBloch]

it is important to apply charge every 1-2 months to keep batteries alive

[@derpherpp]

@@RoeeBloch i ended up replace some cells and the BMS keep draining it. just blinking red light