How to Draft the FRONT BRA TOP Pattern (Bustier / Tube) (watch in HD)

[@GothicRockGoddess]

What happened at 3:36 where you drew contour guide #6? You said to use 7/8" in total, but this was offset from the line you drew down from the shoulder centre, not split equally either side of that line. Why? By how much? Also, why did you switch from inches to cm when marking the style lines either side of contour guide #5?

[@BobbinAndDrew]

hi, *Gothic*Rock*Goddess*, On Contour guide #6, yes total is 7/8". I noticed that in the patternmaking books, they always mention to split this equally. But there are a lot of ways to give the bustier somewhat a better shaping, that's why I have used only 1/4" on the right of contour guide #6 and the remaining 5/8" i have marked to the left of the countour guide. If you are making a mockup, try splitting the 7/8 equally, and make another one by 1/4" & 5/8". You as the designer might visually prefer one from the other. On your question about contour guide #5, where I switch from inches to cm... I tend to work using both imperial and metric system. 3cm is easier to mention than 1 and 3/16" ... 😊 Also, I want to note that depending on the body type, these contour guides can always be increased & reduced. These are just standard measurements that we can use to start with our pattern draft. Thank you for your comment, take care, and enjoy creating!

[@kajalbathija4927]

Hi is the drafting same for all busy sizes?

[@safiraheard5472]

I've seen so many videos where people make it much harder than it has to be, so thank you so much for sharing your knowledge and this method!

[@BobbinAndDrew]

Thank you, @Safira Heard Take care and enjoy creating ❤

[@mukeshshukla5478]

Very nicely explained thanks madam

[@ozachanchannel]

so professional 🥰

[@umimode8434]

Lovely showing how to draft a bustier. Thanks a lot. 😍

[@palesamagoro3720]

I love your videoos so much.. They've made pattern drafting less of a drag

[@LizbethSaudikitchenvlog]

Ang gaLing naman kapatid,na miss ko gumawa ng patern ,nag dress making AkO nung high school..thanks for sharing

[@shairasvlog9531]

galing naman ganyan pala yan ngaun ko lang alam, keep it up

[@gloriabebz9567]

Thanks for this .. please can you make a 3 part cupped corset ... it’s trendy and would love to learn the pattern from you

[@CLINTCHAMTV]

Amazing content!!! I love fashion design!

[@viviannepauloctave8881]

I really like the video can you draft the basic bodice patterns

[@djaydatchi1657]

nice video! love to know how to do this!thanks for the tutorial.

[@SelfcareSteff]

I hope a sewing tutorial and back draft follows soon. I've made the front pattern but a little lost on the rest

[@user-uh3xj5sw4k]

Thanks😊😊

[@Angel-z2g]

Ang galing naman..thank you for sharing your video

[@ninjaniq2786]

Very beautiful. I loved content pretty sissy.

[@kathryngrant582]

help! do i add Seam, allowances after the draft? thanks so much - very easy to follow !

[@BobbinAndDrew]

Hi Kathryngrant582. Yes, only after you have prepared the block will you add the seam allowances.

[@JesusJrRosales]

Wow galing naman po @Happy Family

[@Chellscreativetaste4322]

ganda pagakagwa ng tubetop galing mo tlga sana ako din pra d na buy damit tahi nlng.

[@MissyatHome]

Nice content! 😊

[@happyscooking]

nice video po ......

[@danksbaby]

When sewing this were corset boning added? And if one was slightly busty would you advice to use one for this style?

[@saramoosavi9892]

Hello, do you sell ready patterns?

[@vsingh7777]

3" that u take for bust circle..is it standard for all size..pls tell for all sizes

[@BobbinAndDrew]

Hi V Singh, most of the time it is. However if you want to be very particular, you can measure from the highest point of the bust (nipple) until the empire. That is the bust radius. Take care and enjoy creating.

[@vsingh7777]

@@BobbinAndDrew thanks for ur swift reply🙏god bless

[@gloriabebz9567]

Please make a 3 part corset Thanks

[@rosanggalavlog840]

I love yuor talent my labs wait I have talent like yuo

[@nathanielbio3740]

Hello, at 7:22 why did you extend the patterns by 1/4 inch please?

[@BobbinAndDrew]

Hi Nathaniel, your would notice that when we split our patterns there would be pointed edges, the 1/4 is to give shaping to the bust... However, if the person going to wear this garment woud wear a padded bra or extra foam underneath then you would not add 1/4 but instead a higher amount of 1/2 or 3/4.

[@dhruvpainuly07]

I really like this. Pls release back sort of video also advice why you took 1/2 inch inside at chest below armhole

[@BobbinAndDrew]

Hi, Dhruv Painuly. I have a video explaining the contouring concept on this link kzbin.info/www/bejne/n5C7gH-VrMSNr6M . I took 1/2" at the side seam as I need to eliminate the gaping on that area. I will be uploading the back pattern for my next content. Take care, Dhruv, and enjoy creating.

[@dhruvpainuly07]

@@BobbinAndDrew thank u mam. Looking to seek ur help in future. Thanks a lot

[@BobbinAndDrew]

Hello, @@dhruvpainuly07 , i am currently filming the tutorial... the video will be ready anytime soon. Take care and enjoy creating!

[@dhruvpainuly07]

@@BobbinAndDrew great

[@christinelee6477]

Hi! I want to make this exact kind of top, except with sleeves. So would I just extend side cup A to the neckline? Would the construction of it be any different otherwise? I've made a bodice block, but am new to pattern drafting.. Thank you.

[@milacayanan8961]

It's hard to see it with the white background and also white pattern

[@JesusJrRosales]

Happy family

[@dodongtheexplorer3951]

Ginalingan ng idol ko ayos na ayos idol bakit ndi kita mkta sa fb heheheh

[@BobbinAndDrew]

kapatid, nagdeactivate ako ng fb kanina... itong YT World muna pampasaya sakin ... good vibes tayo dito eh :)

[@dodongtheexplorer3951]

BobbinAndDrew ah okay po cge po basta evryday ka po sken magplayall pacheck nlang po kung napsok hehe maraming salamt po a support mu po idol.Godbless you

[@BobbinAndDrew]

salamat kapatid na Dodong. Support din ako sayo at sa iyong bahay lagi yan!

[@viviannepauloctave8881]

Can you show the number when you measuring

[@ajubble]

Can u plz use a different color back ground. It is hard to see clearly in white in white display

[@BobbinAndDrew]

Pls select watching the tutorial in HD.

[@VogueISHable]

Which pattern making booo do your recommend

[@BobbinAndDrew]

Hello, Ms. VogueSHable ... 2 highly recommended books which are very helpful in creating patterns from scratch are: 1. Metric Pattern Cutting by Winifred Aldrich, and 2. Patternmaking for Fashion Design by Helen Joseph Armstrong

[@angelesmarmol1621]

Me encantaría que traduzcan a Español gravias

[@rachel14rod]

What's contour guide??

[@BobbinAndDrew]

Hi Rachel, I am sharing with you the video explaining the contour guides. When to use and how to use it would help you achieve drafting the patterns without the gapping. kzbin.info/www/bejne/n5C7gH-VrMSNr6M take care and enjoy creating.

[@kumarkumarkumars8690]

Hi Supr

[@ruthv5222]

Que Dios te cuides i dios te bendijs

[@VogueISHable]

Book