Thank you very helpful. My daughter and I are replacing parts you made this easy.
@HowSkills5 ай бұрын
Glad to hear it helped!
@TubularCatTV3 жыл бұрын
Very helpful. I just replaced the same tail light with my $58 Amazon replacement. Much appreciated!
@HowSkills3 жыл бұрын
You're welcome!
@TheWalkerbrenton9 ай бұрын
Wow . New subscriber . Simple . Straight to the point .
@HowSkills9 ай бұрын
Thanks for the sub and for watching in the first place…much appreciated!
@SassquatchTX3 ай бұрын
Many thanks my man.
@crlaw75 Жыл бұрын
Neat instructions and also what is holding the light assembly in.
@HowSkills Жыл бұрын
There are three long screws that stick out from the back of the taillight housing that go through holes in the body and on into the trunk. Then they’re fastened down by some large plastic nuts.
@humbertoheredia17992 жыл бұрын
On the chevy Impala 2016 limited, there are 3 fasteners instead of 2
@HowSkills2 жыл бұрын
Nice. Three are more secure than two!
@moreaucrl3 жыл бұрын
Great video, thanks man
@HowSkills3 жыл бұрын
And thank you for watching!
@donnacish4 жыл бұрын
Good job honey !!!
@HowSkills4 жыл бұрын
This is a really quick and easy repair to do!
@thedirtybubble96132 жыл бұрын
I just tried to change the passenger side tail light bulb and I could not pop the socket out of the assembly. It's really stuck hard in there as if it was glued in. Any suggestions?
@HowSkills2 жыл бұрын
If it's just the bulb that is stuck and not budging, then you can try wrapping packing tape or duct tape around the bulb and trying pulling it out. You can even try twisting the tape back and forth in an attempt to loosen the bulb further in the socket. I've heard of some who have broken the bulb and then removed what was left with needlenose pliers, but you might risk doing damage to the bulb receptacle that way.
@thedirtybubble96132 жыл бұрын
@@HowSkills Thank you for your response. I am having trouble getting the stop/turn signal bulb connector out of the plastic assembly. I turn it 1/4 of the way counterclockwise and it doesn't pop out like the other 2 connectors do. I have been told you need to push down firmly while turning it and tried it with no result. I'm thinking it's corroded or something because it's really stuck in there good. I tore my hand up just trying to get it out of there and no luck. I'll try again later today.