How to enter Recovery mode on NCE Powercab

[@Bnsfmodler]

Definitely saving this video it helped me get my bli ac6000 running again

[@Ian_the_tree-guy]

I just did what you said in the video with my Walthersmainline Canadian National EMDSD70ACE and I recovered the programming that was lost when I put it in the consist with CN 2572 and CN 2851

[@rangerrickl]

Mine is reading "Can't Read CV" No apparent solution in the manual, or on You Tube. NScale Atlas GP-30 locomotive. Help, please.

[@hollyday7947]

My screen shows, no power to main, what’s wrong?

[@hollyday7947]

Does recovery fix “Main Off”

[@pokeyrailfanning]

My problem is when I set it all up and put a loco on the track I hit select loco and when I type the number into the keypad it won’t let me type any numbers if I hit any button it will not show on the little screen I don’t know what to do

[@johng7622]

Hi 👋 you should always hit ENTER key after selection. I.e. select loco, put in number, PRESS ENTER

[@PaulGarwood]

Hello.. I would be interested to know if it's possible to program the NCE with the Hornby auto control feature that's programed into the Sapphire decoder? there is a youtube video of this listed as, 'DCC SERIES: AUTO CONTROL HORNBY ELITE V1.4 (Part 24a)' by ay76..

[@SgtMinuteman]

Not sure about Hornby stuff.

[@choochoocharlie9388]

Does Recovery Program fix short Circuits?

[@SgtMinuteman]

No, in fact you should check your wiring immediately or you can fry decoders or your system.

[@RickyAllen-gb6kl]

I did this. Now my Loco won't move at all. No headlight, nothing. It takes cv changes but acts as there's no power to it

[@SgtMinuteman]

You need to remove it from track power after a reset.

[@MrJulianfrost]

Could this solve a problem of a steam loco not chuffing

[@MrJulianfrost]

Before you say anything like it may not have sound it is a broadway limited and it did chuff at one point

[@unionpacific8330]

Anyway to reset the cab to factory

[@SgtMinuteman]

The Cab controller is Eprom chip memory so there is no overriding it. Do you mean the actual reset of the train dcc decoder? If so this is the video to do that.

[@unionpacific8330]

No sadly not but has been a helpful video thanks anyway

[@unclebrado8635]

This is the worst video on this topic - it should be ignored.