How to fit the Van-X T5, T5.1 Cup Holder Replacement [Fitting Tutorial]

[@hooters28]

Thank you so much for this video. I was having no end of trouble getting my old one out. All sorted now though thanks to you. Cheers.

[@fortygreen]

Just fitted mine after buying from 'The Caravan, Camping and Motorhome Show' today. All went ok but seems very tight when pushing closed on the final inch and when pulling open at the beginning as well. Hopefully will loosen up.

[@HelenBeaumont]

What colour wire do you not connect back up again?

[@ginapieroable]

Where can I get s replacement spring and wheel thingy?

[@deantaylor5799]

A thousand attempts to get that spring cap back in.

[@markiep5]

There’s 3 wires where does the third one go

[@brettsewell701]

Yes where does the third one go. No instructions on this anywhere

[@stevenlea4500]

it's for the light

[@ribzzzz]

Not as smooth as the factory cup holder.. in fact don’t attempt to pull it out unless you workout 😂 going to strip it out again tomorrow and hopefully find the cause

[@JaeDubbya2011]

Yeah I noticed this. I found the traveler wheels were really tight in the Van-X unit, I tried adding a small amount of grease but it didn't seem to help. Did you manage to make it easier or did it just get easier over time using it?

[@joebristowtechnologicalbre2073]

That’s not the way to do it. Never cut your loom. There’s a plug.

[@chrisdavies-kiwi]

Is it easy to get access to the plug to disconnect?