How To Fix A Shaking Steering Wheel When Braking - Why does my steering wheel shake when braking?

How To Fix A Shaking Steering Wheel When Braking - Why does my steering wheel shake when braking?
This is an easy fix and a fix just about anyone can do in their garage on a Saturday afternoon with basic hand tools. You'll need new brake pads, and a shop that can cut, turn or resurface brake rotors for you. The cost to have your old rotors resurfaced is about $25 each, whereas a NEW brake rotor can be $100.00! SAVE SOME MONEY!!
(in this video: How To Fix A Shaking Steering Wheel When Braking,why does my steering wheel shake when braking,car shakes,shakes when braking,car shakes when braking,why does your car shake,why does my car shake when i brake,how to fix a shaking steering wheel,car shakes when i brake,car shakes when i apply the brakes,how to replace warped brake rotors,pontiac g6 front brake job,how to replace brakes on a pontiac,diy front brake replacement video,how to fix bad brakes)

[@VinylVillageGarage]

Simple fix just don’t push on the brake pedal. 😂 Nice job buddy.

[@ArrowheadGarage]

You got that right! Who needs brakes any ole how!?! Hahahha

[@VinylVillageGarage]

@@ArrowheadGarage my thoughts exactly, plus the money saved on brake pads will buy you 1.654 gallons of gas.

[@johnmorgan7262]

Very good basic DIY - but make sure you look at the specifics of your car. Many do not use standard bolts or hex fasteners for instance. You do NOT want to be using a standard socket on an e-torx bolt - for instance.

[@ArrowheadGarage]

Very True, make sure they are standard nuts/bolt heads... otherwise get the correct fastener for sure!! Great TIP!!!

[@michaelburtin3457]

Great video was the steering wheel still shaking without hitting the brakes a little bit

[@ArrowheadGarage]

Maybe a bit, after doing the brakes I did do a tire rotation and balance on the tires.

[@williamwhite1596]

Very clear instructions video ! Thanks ! God Bless !!!

[@ArrowheadGarage]

Glad it was helpful!

[@donaldhalls2189]

Normally I put the spreader between the two pad's then release the breeder slightly, then push the cylinder apart allowing the fluid out, rather than push it back through the system, great tutorial, great job, thanks for sharing, all the best to you and your loved ones

[@ArrowheadGarage]

i havent tried doing that before but when i go to do my daughters honda will give it a try! Thanks for the tip!!!

[@Rustrevivalgarage]

Need to turn my C10 front rotors. Got a little shimmy on light braking. Thanks for the video!

[@ArrowheadGarage]

You betcha, can't wait to see more vidoes on that LeMans soon!!