How to Fix loss of suction & Pickup Performance, in a Dyson Dc33

Check out my Patreon www.patreon.com/VacMaster1991...
As an Amazon associate, I earn from qualifying purchases
Click here to check out my storefront (Paid Link) www.amazon.com/shop/vacmaster...
For recording
Nov 2021 and on Canon C100 Mark II
Dec 2020 and on Samsung S20 Plus
Dec 2019 and on Note 10 Plus
May 2018 and on S9+
Pre May 2018 Canon PowerShot SX540

[@argentik82]

I have recently (January 2021) got one DC33 same as this one, for less than 30 dollars, plenty of dirt, but a perfect clutch and belts, brushbar, ducts, everything! I fully cleansed as you did, and now it runs delightfully and it's nuts powerful!

[@johngordonwyland]

Watching from New Orleans

[@VacMaster1991]

Hi from Phoenix

[@nonelost1]

Recently, I found a DC-33 and a DC-07 right next to each other sitting by a dumpster. I’m trying to make one good one out of two bad ones. I’m hoping to save the newer DC-33, but it needs new brush roll bearings. How do I pull the bearings out?

[@VacMaster1991]

Which bearings

[@eileenkelly6371]

Hello - do I need a new clutch or just the bands if my roller isn't spinning? I wasn't sure what to purchase. is the only way to know is to look at the white piece you mentioned to see if it's worn?

[@VacMaster1991]

You have to buy a new clutch. The belts don't come off the clutch.

[@eileenkelly6371]

@@VacMaster1991 having trouble with third screw, the one holding the clutch cover on, I cannot get it to grip and get it to screw back in, tried for over an hour. About to give up from frustration hoping I just don’t need third screw to go in for it to work.

[@VacMaster1991]

@@eileenkelly6371 the 3rd screw is probably necessary for it to work correctly

[@eileenkelly6371]

@@VacMaster1991 yea. I just can’t get it to catch to screw in. So frustrating.

[@zachhot]

My roller is spinning great (cleaned bearings even). However the vacuum is not picking anything up. I recently took the brush out and cleaned it thoroughly before reinstalling it. Reinstalled it and now it does not pick up. Suction is still strong. Filters are cleaned. Internals cleaned yesterday as well. Head just does not want to pick anything up in either setting on head knob. Ideas?

[@VacMaster1991]

Did you check the clear plastic tube on the base

[@zachhot]

@@VacMaster1991 yes. All tubes have been checked for obstruction as well as gaskets cleaned.

[@VacMaster1991]

Not sure. I would contact Dyson

[@seeshell3738]

Yes I have suction everywhere but the borrow these vacuum’s are a p.o.s

[@zachhot]

So...what is the fix...?

[@VacMaster1991]

Washing filters.

[@redlegsrick8514]

Why aren’t you cussing. I’ve changed that clutch Did you hear me?

[@VacMaster1991]

Lol. Advertiser friendly content