Great video. Just a few fine points not mentioned: turn off spa at breaker before draining, back flush jets with fresh water hose to push out residual old water, unscrew drain plug in cabinet to get old water from lowermost plumbing, spray down shell with fresh water to remove chemical film. It’s hard to make a video and include all the little steps but they are important too
@tobiasmindebremar2147 Жыл бұрын
In my instructions it tells me to refill hot tube after pipe cleen, drain and refill again. Is this nesesery? My got tub is 1850L and I pay for whater😅 that is almost 6000 liters of whater 😆
@jw7114 Жыл бұрын
If you don't have the flushing liquid what else can you use in replace of that?
@amatvborders-ot4ro Жыл бұрын
what about the dirty water in the pipe work ? you just left it
@jefferydomschke2522 Жыл бұрын
Do you shut down all power before cleaning the hot tub.?
@tobiasmindebremar2147 Жыл бұрын
In my instructions it tells me to refill hot tube after pipe cleen, drain and refill again. Is this nesesery? My got tub is 1850L and I pay for whater😅 that is almost 6000 liters of whater 😆
@armani007E553 ай бұрын
Once drained, fill up a few inches just enough to use the pump to drain again. So pipe clean run for 30 min or so. Drain.... re fill agian a few inches then drain again. Finally re fill. done.
@danieljimenez7282 жыл бұрын
Theoretically after draining with sump pump there is still residual water in the plumbing, correct? Will this water containing the cleaning product effect the new water being added?
@drdrew32 жыл бұрын
You are correct. There are segments of hose below the lowest ports which will not drain with a sump pump. After refilling a few inches I run the sump pump again to get out this stale water with concentrated purge chemicals. Before that step I also rinse the shell surface with fresh water - just wiping it like he did only spreads the residue into a thin film. This process is only done every 3-4 months so better to take a few extra minutes and do it right
@travishopper5133 Жыл бұрын
I read you're not supposed to run the tub without filters. Is that just being overly cautious?
@sugar1ips Жыл бұрын
do you keep the air vents open or closed?
@italiad10132 жыл бұрын
Good video n fella👍
@josh.hellwig3 жыл бұрын
Shouldn’t you wait to put chlorine in once the tub gets up to required temp(90 degrees F)?
@drdrew32 жыл бұрын
Add the chlorine regardless of temperature
@baldydancer43153 жыл бұрын
If you use a pump, does water with the flush chemicals stay in the pipe work??
@HotTubsHappy3 жыл бұрын
That is somewhat the case. A couple of ways to alleviate this, one is to run the hose through the jets as the water drains, this rinses out any cleaning solution or the more effective solution is that you could purchase a wet and dry vacuum and vacuum the jets to maximise how much water you remove. Hope this helps!
@drdrew32 жыл бұрын
Most spas also have a drain cap someplace inside the cabinet. This is a slow but effective way to drain the pipes located lower in the plumbing
@armani007E553 ай бұрын
@@drdrew3 drain plugs are the worst and tend to break after so many screw on/off. I'd avoid drain plug. But that's just me.
@c4rm03 жыл бұрын
i got told to use the chlorine shock treatment and add the filter back only when the pool reaches a certain temperature 30 degrees is that correct ? also when the hot tub is refilled and turned back on it goes through a purge cycle is that just a case of turning on the jets ? thanks great video btw
@drdrew32 жыл бұрын
Purge cycle is designed to prevent air lock by flushing air from the system that was introduced during the water fill. You can shock before the water is warm as he did - you are just trying to quickly establish a chlorine reserve which is going to degrade each day regardless of the water temperature
@WeatherNut27 Жыл бұрын
Great video! First time hot tub owner here. Its empty still. Should I fill, flush, drain and fill again?
@markbellingham45363 жыл бұрын
I have a hydropool but very helpful info 👍👍👍👍
@maylovesdailyprofit3 жыл бұрын
So you pour all the chemicals where the filters go, or can you pour them straight into the hottub, because that's what I have been doing
@HotTubsHappy3 жыл бұрын
Hello May, either way is good we just prefer to go through the filter housing as a rule. But don't worry both ways will work and won't do any harm to your tub!
@kingbee4474 Жыл бұрын
@@HotTubsHappyIs it ok if I use a chlorine dispenser that floats in the hot tub at all times?
@irenethompson3137 Жыл бұрын
Super Easy Install & Usage
@samuelstarr74664 жыл бұрын
Very informative video - as always, a professional service from Happy Hot Tubs
@maylovesdailyprofit3 жыл бұрын
Hi so while you are draining the hottub, do you leave the filters in water so it doesn't dry out
@HotTubsHappy3 жыл бұрын
Hi there, when draining a hot tub always remove the filters. It does not matter if they get dry but it is a good opportunity to clean them whilst draining!
@kevingallagher1182 жыл бұрын
Do you turn the power off when training the hot tub?
@HotTubsHappy2 жыл бұрын
Yes. Make sure you turn the hot tub off when draining.
@TheRealBatCave3 жыл бұрын
Dont u 1st make sure the alkalinity and ph r at the appropriate levels as the chlorine/bromine wont be active unless those r balanced 1st?
@HotTubsHappy3 жыл бұрын
That is correct in theory! You want to balance Alkalinity then PH then Sanitiser (in that order) but we always feel it is important to build the sanitiser level early on in the process. Chlorine/Bromine is still active when the PH/Alk is imbalanced but not as effective. The other issue is that the PH and Alk reading may vary as the temperature changes so it is best to wait until over 26 degrees to balance those. So yes you are correct but the logic here is based on the two above points. Hope this helps!
@TheRealBatCave3 жыл бұрын
@@HotTubsHappy yup, thanks.
@drdrew32 жыл бұрын
You are correct when referring to routine daily chemical balancing. But when super chlorinating brand new water as in this video the order is insignificant
@rociofiguereo5541 Жыл бұрын
Justo la informacion que necesitaba
@vizaalbastiampillai40323 жыл бұрын
How to close the drainage when filling
@drdrew32 жыл бұрын
To stop draining you just unplug and remove the submersible pump