Hola fish FTW! It took me 3 hours but my lexa 400 is lubed and ready, thankyou sir🙌
@henryschmidt6362 жыл бұрын
I hope your "washing" does not damage the ball bearing in the palming side plate, the tiny ball bearing under the driveshaft and the instant anti-reverse. WD-40 will leave a shellac when it evaporates. Rubbing alcohol is a better alternative. Have you found your maximum drag to have decreased? The drag should never be contaminated by gear grease. Only use drag specific grease. Good luck fishing in your adverse environmental conditions.
@holafish2 жыл бұрын
Hey Henry, thanks a lot for your comment, I appreciate it. Regarding the washing, as mentioned in the video, I know that many people do not agree with that, but these ball bearings already got salt water, so, do you think a bit fresh water will make any damage? Even so, I agree with you that maybe alcohol is a better alternative, I will try that next time. Now, no problems until now with the drag. This reel has almost 30 pound drag, and I never used the maximum becasuse we like to fight the fish, not to drag it, so, to be honest, I cannot feel that difference. Thanks for your time, and again, I appreciate your observations. You are very welcome to come to Costa Rica to fish... :)
@henryschmidt6362 жыл бұрын
@@holafish I see on your one jigging video that you fish a place named El Jo Jo? I fish a place named El Jobean in Florida! I enjoy your videos and look forward to more. Good luck in your fishing endeavors.
@holafish2 жыл бұрын
@@henryschmidt636 .. the place name is el Jobo, very similar to your place. I will upload videos soon, thanks a lot for the support 💪🏻💪🏻💪🏻
@lisa-mariestettner64512 жыл бұрын
Which reel size is this? :) and thanks for the good explanation!
@holafish2 жыл бұрын
It is a 300 reel. Thanks for watching, I appreciate it
@kabanchan5768 Жыл бұрын
what handle is that ? and braid you recommend ?
@andrewwang7666 Жыл бұрын
Hi I cleaned my reel which is the same one as yours. Then I realized there was a small pin left after putting everything back. Can you help to identify where should i put it back?
@TheSilverCube862 жыл бұрын
@26:05 the washer goes inside the bearing, not outside the handle.
@holafish2 жыл бұрын
Thanks a lot for the observation
@fadelover1232 жыл бұрын
Nope. It sits between the roller bearing and the drive shaft bearing as he installed it. It adds to the belleville stack allowing extra pressure for more drag.
@alanekmen8660 Жыл бұрын
Does lexa 400 tws have dual support pinion gear?
@jnewc4130 Жыл бұрын
I just took one apart and I wanna say yes but I'm not sure what you mean by dual support? There was 2 springs that sit next to it on little posts
@alanekmen8660 Жыл бұрын
@@jnewc4130 dual support means that the pinion gear i supporten by two ballbearings. One on each side of the pionion gear.
@coretan6749 Жыл бұрын
pinion gear is stainless steel? 😢
@arifariffin6468 Жыл бұрын
it is stronger than Brass and aluminium alloy though 💪🏻