How To Guide- Swapping Type Bars on a Manual Typewriter -Full tips and tricks

[@amsterdamtypewriter6410]

Liked this video before even watching it. Good stuff.

[@ultimatetypewritingmachine6976]

one additional tipp: hold the assistant-bar in front of the basket in order to see how deep you need to push it in to reach the target typebar. Then use a duct tape to mark the spot on the assistant bar where it should reach the beginning of the basket. Then simply push the assistant bar in. Up to the duct tape and you will be pretty much exactly where you need to go without wiggling around and watch for bouncing typebars. The wiggling part can be a little hard on some typewriters, so I find this method more easy. Thank you for your great videos, Gerren! 👍🤩

[@delmardennee2024]

Great video thank you Gerren

[@chrissoucy2224]

Very helpful! Any suggestions if one does not have a spare 'assistant' curved fulcrum bar?

[@linux4samir]

Wonderful and excellent video but your voice is very low.

[@LazyDogTypewriters]

Oh my, why didn't I think of using a spare fulcrum ring??? I've used wd-40 tube and its NOT strong enough.