How To Install A Honeywell Thermostat - Instructions STEP-BY-STEP!

[@markrobinson7875]

Thanks, watched your video because my emergency heat was not working. After watching I realized that the white wire was put into y2 instead of w2 (done by installer). Switch the white wire to w2 and the system is working beautifully, which is a good thing because it's going to get to 20 again tonight - looking forward to being warm. Thanks again...

[@jamesdriskill5784]

Just happened upon you today. So far I have watched 2 of your videos. You have a great channel.

[@TheExcellentLaborer]

I appreciate that James! I try to keep every video informative. Take care!

[@davidharrison3074]

I like using Honeywell units because they have fairly common looks with most of the units. I always tell people to also make sure to turn off the power with anything related to the furnace etc. Safety is important. Leveling the units are very important especially if you have the old mercury style. I've always run 6 wire thermostat wire solid color with stripes, easier to color code and in case someone gets a newer furnace or air-conditioning and heat pump. Great unit and easy set up instructions on the key pad. Great job Josh 🔨👍🏻

[@TheExcellentLaborer]

My last house I had a Honeywell unit similar to this, except it was analog buttons. I use it for years with zero problems. I definitely recommend them! Yes, I think it is very important not to power the thermostat when you were trying to wire it. Safety and it could ruin the unit. It sounds like we both think the same way, David! Thank you and I appreciate you taking your time to comment. Take care!

[@davidharrison3074]

@@TheExcellentLaborer I really appreciate all you do taking the time to do these videos. It also is great that we do understand a lot of things. I thank my Dad and father-in-law for teaching me so many things as well. You can always have room for improvement and guidance. Thank you for your wonderful words as well my friend. 🔨👍🏻

[@shaggyfilms]

Love seeing some smart home content on here!

[@TheExcellentLaborer]

Thanks, Tyler! In today’s world, I feel like smart technology is a must. If it’s available, why not use it! Thanks for watching!

[@joannothing]

Thanks for the video! You are the only one who explains where the brown wire goes.

[@joewenzel5142]

About 3 years ago I had to replace an analog mercury HVAC control on the wall that was installed in 1983 with a digital Honeywell one. Videos such as this are priceless. And like you suggested, I too took a picture before removing any wires just in case the new digital one didn't work. It did. I had to strip the wires so they could be attached in the correct slots. Would I have attempted this w/out youtube absolutely not.

[@TheExcellentLaborer]

I’m glad you were finding my videos helpful. Yes KZbin has change the world when it comes to DIY. The new thermostats are much better than the old ones. Thanks for watching Joe!

[@boatlover8856]

Great video it helped me a lot! Thanks

[@MrJpiarull]

Looked at this thing as well as the one that can work with Ring. I ended up going with the T5 7-day programmable, solid product.

[@zafarullakhan9557]

Thanks Very helpful

[@bryanhenderson7792]

Great tips Great j I will be following you on your work

[@TheExcellentLaborer]

Thank you Bryan for showing interest in my content. I do a lot of DIY projects step-by-step. Stay tuned!

[@dastec7120]

Thank you sir

[@TheExcellentLaborer]

No problem. You are welcome!

[@repairking1990]

Them DIY big box stores sell that crappy retail version of thermostats. This one in particular isn’t worth $50. You have to punch the buttons with your fist for it to recognize. But if you get a “non retail” version, that Honeywell pro 9000 is nice! The screen resolution and touch responsiveness is like todays iPhone 👍

[@JustinsAutoWorks]

I've watched a lot of your videos and they are very helpful so thank you. I have a quick question though about selecting system type, how do you know which type you have? Did you select heat pump because that home has a furnace?

[@Oneklickmedia]

I installed it perfectly like this but my Red wire was RC. Hopefully changing to R will turn my heat blower! You’re the only one that show same 6 wire configuration: orange is o/b and my white is w2/E aux

[@naro1213]

Great video as always. Any chance of ever doing a concrete counter top?

[@TheExcellentLaborer]

Thank you! I am building an outdoor kitchen attached to my garage this summer. I’m debating about a concrete countertop there. Stay tuned!

[@joewenzel5142]

How does it get the outside temperature? off the internet?

[@TheExcellentLaborer]

Yes, I assume it does because I don’t have anything that is going to the outside from the thermostat.

[@jharr03f]

I have a b wire instead of o. Does it go in the w-o/b slot?

[@rogerbradley7509]

I have 4 wires. A yellow, green, white and red. Will this work for me? My friend gave it to me and I want to replace the old one I have. Thanks.

[@omarnoah]

Hello. How complicated is installation going to be by adding the C wire? My house is old and does not have that cable. Also, will it be setup besides thermostat? - is there a separate video for complete setup? Thank you

[@yobanyrodriguez322]

An you add a wired remote sensor to this thermostat ?

[@melodyluvsherhobbies9454]

I have an E wire and no where to put it. What should I do?

[@TheExcellentLaborer]

I would recommend you contact the thermostat manufacturer. Most of them are more than willing to help you install their thermostat. Good luck with your installation!

[@melodyluvsherhobbies9454]

Thank you!

[@too-da-loo]

I have moved into a new place which has a gas boiler for heat. I have one of these from my old house. Looks like the gas boiler is just black and a white wire. Can this still be used?

[@donyemonroe4577]

What if I've tripped breaker on air handler how do I reset currently no power to thermostat ????

[@dmariewalker6880]

My electric was off for hours due to a storm, when my new furnace & thermostat was installed last October ,and setup the installer didn’t set it to memory and I was screwed, the thermostat asked me questions I couldn’t answer. The AC kicks on, after cooling it run’s several minutes longer without cooling 🤷 what did I do wrong? TH8321 WF1001, I have no manual. Installer can’t get here till July 29. Can you direct me some where for help? TY

[@RussellClarno]

WHAT IS THE CHANGEOVER VALVE AND HOW DO I KNOW WHICH I HAVE? HEATING OR COOLING?

[@markrobinson7875]

Change over valves only apply to heat pumps. If you have a heat pump and you set the thermostat to the 1st option and you set it to heat and the ac comes on then you know you chose the wrong option. The first option set the flow to reverse the flow of refrigerant making your condenser (outside unit) an AC unit and taking the heat from outside and sends it to the evaporator coil inside your home making it hot, thus heat. If you have a regular ac unit (non heat pump) then it doesn't have a change over valve and you don't use the "brown wire" (sure looks orange to me).

[@Jnu925]

This is prob a dumb question. However, I have 2 thermostats, upstairs and downstairs. Do I need to purchase 2 of these?🤔

[@joewenzel5142]

Interesting it wants you to heat your home no higher than 69 degrees. Big brother is everywhere now.

[@TheExcellentLaborer]

Hey Joe! Yes, Wi-Fi and Internet has taken over everything. It is amazing!

[@Poorboyforever]

Your only setting it to 69 for verification purposes only. After set up,you can put it on 80 if your rich.

[@saljablo2767]

Waiting impatiently on that shirtless video !