How to install a rudder angle sensor on a sterndrive boat

[@salvareoo.l8562]

Un video chulo,como van conectados los cables? No se apecian en el vídeo.gracias un saludo

[@josephkordinak1591]

How has it been holding up? Looks like it was binding up when you went hard over and bending the arm on the sensor.

[@nordicDIYchannel]

Hi It has been ok Sometimes it jumped out but I fixed that with some wire 😁

[@mchaves7663]

You're amazing. Thank you

[@johnpowers253]

I'm serious now with the boat in my garage and the lid off, indicator in hand. First, I can no longer move that fast. 2nd, what is to keep the vertical arm from rotating on the stud below?

[@zsoltkovacs2229]

Thank you for this usefull video. Great job.

[@TerryLane-l7w]

Can you wire to autopilot

[@gerritvos8153]

Great video. Where did you buy this product? I could really use it.

[@nordicDIYchannel]

Hi. I bought it on Wish. But I have seen it on amazon and ebay.

[@brayansanchez8260]

So only one wire goes on the white piece ?

[@nordicDIYchannel]

Hi. Two wires. One to the guage and on to ground.

[@brayansanchez8260]

Does it matter which side it goes on ?

[@johnpowers253]

@@brayansanchez8260 not on mine

[@mchaves7663]

I wonder if we could 3d print the parts.thanks for the video.awesome

[@moonhand8311]

Viewers would appreciate the details of what wires are connected to what. That's the hard bit in that these things from China come with useless instructions.

[@nordicDIYchannel]

Mine came with a clear instruction so I didn’t think about that. I will incorporate more details gowing forward. Thanks for the great feedback.