How to install Alpha Brite nocks

[@BillSmith-u7u]

You don't need hot water to dip the nock end of the bolt into it. You can used compressed air. Put the 1/8" rod into the arrow shaft, turn the bolt upside down and turn the compress air can upside down and press the spray nozzle of the compressed air can so that it releases cold air from it. The cold air coming from the compress can will cause the glue on the arrow shaft to allow you bang with a hammer the rod and it will push out the nock out of the shaft. The most important step is turning the compressed air can upside down when you start spraying. it caused the compress air can to get really cold and the air will freeze on the vanes of the bolt. You should wait about a minute to start banging the rod. I did 6 shafts in about 5 minutes, doing it the way I described. Good Luck

[@coastalcustomlure]

Freezing with electronic compressed gas duster works without a hammer. The weight of the 1/8 x 26 rod falling on the frozen insert works all by itself.

[@ezequielcandelario2906]

Well and clearly explained. Thank you

[@mattp9029]

Tenpoint should be doing better. This is a whole lot of BS just to convert their equipment.

[@Gokywildcats11]

Ten point has you when you buy the product,. With the nocks and bolts

[@unklebuck62]

Fletch tite says not to use on carbon arrows. How does this effect these 35$ a piece bolts

[@cloyd1950]

Use Compressed Air Duster spray for computers. Spray it in the end and freeze the insert and then knock it out. No need for hot water.

[@kevinmason4010]

nice demo. Thanks.

[@ES-iz4wf]

Do you have a link to that exact kit in this video? I have the same bolts and experience the same issue with the lighted nock falling out. I almost lost one last night but luckily found it next to my Titan M1 after I lowered it from my treestand

[@dimebag117]

Does the nock alignment key come with the nocks or bases or a separate tool all together ? If so, where can I purchase the nock key ?? Thanks bud.

[@Gokywildcats11]

How do you know the size of nock that will fit your bolt size

[@shantelstewart6326]

Theirs a chart on the back of the kit