These are the flow series halo rings from lighting trendz. They are actually installed inside of your fog light assembly versus the stick on waterproof halo rings. These RGB fog light rings have over 200 color options when installed!
Пікірлер: 15
@eric316m2 ай бұрын
Came out clean af! Nice work bro. Straight to the point vid. U got my like
@canyou_heminow2 ай бұрын
@@eric316m ty
@DrippDroppz2 ай бұрын
@@canyou_heminow I was unsure about the dielectric grease. Where are you putting them on, the connectors that lead/come from the halo ring?
@canyou_heminow2 ай бұрын
@@DrippDroppz Just the electrical connectors. It will help keep moisture out.
@derekjoye64172 жыл бұрын
keep me up!! Young buck ! mine lower 2"" 2010 scion xb rs,7.0
@Dejahndrk092 жыл бұрын
Those are clean👍🏾
@canyou_heminow2 жыл бұрын
TY🙏🏾!
@BLOODYDEATH1000Ай бұрын
I've tried this method multiple times for my fog lights even went to the extent of putting them in the oven for 20mins on 280°F to no success, im starting to believe mine are permasealed.
@canyou_heminowАй бұрын
@@BLOODYDEATH1000 I hope u figure it out. Maybe try to gently pry it apart with heat.
@derekjoye64172 жыл бұрын
send me Link,. my hallo stopped after a week, and my headlights conversion, hallo stopped, eyes still working 4months later
@canyou_heminow2 жыл бұрын
I ordered mine from lightingtrendz.com
@DesertEagle906 ай бұрын
Question bro, when you applied the glue/epoxy, did you apply it on the outer side of the LED ring?
@canyou_heminow6 ай бұрын
No. They come with adhesive already on the back. Then I used a little hot glue just in case the adhesive failed. I only used the silicone to seal the assembly.
@DesertEagle906 ай бұрын
@@canyou_heminow so was the halo ring inside or the outside? That looked so dope I couldn’t even tell!! 😂 I’m doing this myself on my WRX
@canyou_heminow6 ай бұрын
@@DesertEagle90 Thank you! The rings are on the inside. Just install them and put the lense back over the top with clear/waterproof silicone.