How to install Switchback Turn Signals and Hyper Blink Termination Resistors on a 2020 Ford Ranger

[@prothean]

my 2020 ford ranger headlight indicators dont even have a wire plugged into them, they got lightsbulbs in them. So ever since ive owned it ive been using my foglight indicators lol. im not good with vehicles

[@MicahMartinDIY]

LOL!

[@norristhomas87]

I have a 2021 ranger. I put the resistor on the green and yellow wires also, but I'm still getting hyper blinking.

[@MicahMartinDIY]

I would use a multimeter to make sure you have the correct two wires. You should see power jumping up and down when the signal is on.

[@PrelandRanger]

How are you getting 300+ miles until empty ? When I fill up my 2020 ford ranger xlt sport 4x4 most of the time it only gives me around 286

[@MicahMartinDIY]

I have made a few upgrades that do affect mileage. Check out my Ranger playlist!

[@justinflores2012]

Did you mount your resistor to the truck? Or did you use tape?

[@MicahMartinDIY]

At firstI just zip tied them to the rest of the harness, but they were rattling around, so I used double stick tape and stuck them to the bottom of the headlight well opening. (hope that makes sense)