How to make 90* elbow with Duct Board

Hey guys in this video I demonstrate how to make a 90* elbow out of duct Board using a speed square and template with 22.5 degree angle. Please Like & Subscribe
share.getjobber.com/mzrzvqe
Jobber is the tool I use to book more work, schedule smarter, and get paid faster. Sign up today for a 2 week free trial.
More videos down below 👇
Malco FasGroov Shiplap Tools For Duct Board review/demo
• Malco FasGroov Shiplap...
How to cut Duct Board W/Amcraft Layout Square /V-Groove method
• How to cut Duct Board ...
Cutting Duct Board W/ centerline method using amcraft tools
• Cutting Duct Board W/ ...
HVAC Install: Rough-in Day
• HVAC Install: Rough-in...
Milwaukee Packout HVAC Installer Edition
• Milwaukee Packout HVAC...

[@donaldhoudek2889]

Outstanding video!!!!! Thank you, so simple now.

[@DonaldDucksRevenge]

Gorgeous. Precise.

[@EMSAIRCONDITIONING]

Great videos ! I was looking for this videos for long time .. thank you so much !

[@franklinmesa3876]

Thank you so much I really appreciate it!

[@joemc111]

You sir are an ARTIST.

[@JavierCruz-qw7th]

GREAT FREAKING VIDEO, BROTHER!

[@hectorposada1512]

Donde compraste el palto del angulo yo llevo casi 2 años en este negocio y me gusta esta herramienta es muy practica

[@user-uo3wl2oq5n]

👍 thank you homie !

[@scottschweigert1657]

wild that its structurally solid with just tape

[@rightconditions2010]

Grasias.

[@tjsh11]

Hey Sheet metal worker here, curious, if you used the same standards for metal elbows, would the airflow improve? (I.E a full throat elbow) Using the miter rise formula to get a full throat elbow on that 15" wide duct, you'd have to cut the throat for that middle piece at approx 11.5 inches instead of 3 inches. though maybe that's just not practical?

[@marioleonel9947]

Thank you so much 👏🏻👏🏻👏🏻

[@franklinmesa3876]

Do a 45 next

[@minhngo2759]

How do you connect the transition 14x8 to 12x8 duct?

[@SPCFreed]

Does this work the same way if the 90 is on the shorter face of the duct?

[@junixsk8]

You said staple, but I didn't see where they went. Isn't it required to be stapled?

[@crisken5105]

can this be done with sheet metal?

[@dineshbhoibhoi583]

Sir I am duct fitter you have vacancies tell me

[@michaelhouser4673]

You realize you could have taken the number 6 cutter and went around your lines and it would have made the one inch tab all the way around so when you connect it you dont have to fight to line it up you did that way harder than it had to be

[@franklinmesa3876]

Thank you so much I really appreciate it!