I run a 1 to 1 set up two Trophy ridge hitman stabilizers 6 inch. Sits perfectly in my hand. No sock in the bow. Works great
@MrChulaFreak5 жыл бұрын
Thanks for the video! I was looking at ordering one of these and wasn’t sure how hard it was to install!
@OfficialTrophyRidge5 жыл бұрын
It is pretty darn simple as you can see. Let me know if you have more questions.
@jcassell1113 жыл бұрын
Can this be used on a left handed bow?
@fernandobelone38765 жыл бұрын
Can you order the kuma grip separately?...looks nice on the divergent...👍
@OfficialTrophyRidge5 жыл бұрын
That grip comes on a Legend Series bow that you can only get at a dealer. You would need to contact your local dealer to get that grip. I like the feel of that one on my divergent.
@fernandobelone38765 жыл бұрын
@@OfficialTrophyRidge Okay...thank you...👍
@doeslayerdiaries Жыл бұрын
Does the main mounting piece come with everything else? I can’t find mine
@tripp101211 ай бұрын
Can you change what side the back stabilizer goes on
@wesmac683 жыл бұрын
Thank you the shop put my nand I could not figure out how to take them off.
@alexbobbitt9184 Жыл бұрын
Can I use any stabilizer with the hitman bracket?
@madman432000Ай бұрын
Yes with some modifications maybe. I just bought one of these and mounted my Limbsaver front 10" and a BeeStinger 6" to the rear. The Limbsaver front stabilizer is too fat to fit in the recess area so I had to grind it down to fit inside it. Took a bit but it fits pretty good.
@appalachianpursuit29243 жыл бұрын
Can you buy the mount for the back bar separately
@amota923 жыл бұрын
Yes I found it on Amazon for about $80
@jbgjude164 жыл бұрын
No more music. Haha too loud and is more distracting than anything else. 😁
@nypigskin4 жыл бұрын
I don’t understand why the stabilizer is made with the logo orientation the way it is. I own the 12 inch and when installed the Trophy Ridge logo ends up being upside down. Now looking at this video I see the same thing (2:59). Why? I rotated my socket 180 degrees and the logo is correct when tightened. A little inconvenient but it works. Don’t you people look at your product say, hey, the logo is upside down. We need to fix this.
@blakebarnett50784 жыл бұрын
When you screw a bolt into a nut it's never perfectly consistent. Also when they are putting the sticker on I can see how it could be incredibly hard to tell where to put the sticker unless you put the nut on each stabilizer that is going to be packaged with it. And even then if that nut or the stud gets screwed in and out several times it will change. You can put a washer behind it or thread tape on the threads to adjust how many rotations it makes and you get the orientation you want.
@SinnerSince1962 Жыл бұрын
@@blakebarnett5078 Not that difficult, dude, they should put a backing locknut in the package. When the logo is where you want it, lock it down in place with the nut.