This is very helpful. I am about to do the same thing on a H9 46% Ultimate. I have a Jeti DS-16 and plan to run the CB200. I was going to run each of the 8 aileron servos to their own channel, but I may copy your method.
@TerrariumFirma Жыл бұрын
Can Jeti transmitters have differential on more than just the aileron? I have twin rudders and want them to have differential.
@billneudorf913 жыл бұрын
Hey this is very helpful thanx for the video I'm setting up a 100cc edge with dual aileron servos, but my transmitter doesn't have enough channels, but according to your video i can program the aileron servos, adjust the end points accuratly so they are matched perfectly and connect them together with a y harness? That would be GREAT! My radio doesn't have enough channels for each servo to have its own port in the receiver! And I feel like spending more money into buying a new transmitter
@djmoosecom3 жыл бұрын
Yes you can, however I would not suggest using a Y harness for two aileron servos in a 100cc plane. Typical servo connectors are rated for 5 amps of power before you start to have voltage drop. You can use a Y harness for the signal wire, no problem. However I would suggest running separate power and ground lines from your RX to each servo at least.
@preauzalam34833 жыл бұрын
Hi im having a difficult time using the dpc-11 programmer. I believe there is an issue with the driver i hae downloaded for my computer but i cannot download the latest driver.
@djmoosecom3 жыл бұрын
In this video I used the DPC-10, and I just received a DPC-11 to test. Message me if you're still having problems.
@UserName-bp7gv3 жыл бұрын
Hello my friend! Give me please drawing. I will very pleased. I wont very well plane!