How to put the chain back on an Echo Power Pruner small pruning chainsaw

[@louisianabrokenenglish]

Hey Jenny thank you 🙏🏾 for the instructions you been a tremendous help ❤❤❤

[@mikes1798]

Thanks for posting this, you saved me. Rented this model and the chain fell off after about 10 minutes of use. I’m not exactly near the rental place and this saved me a bunch of time.

[@flintknapper6039]

I guess you figured out you put the chain on backwards and that the two nuts holding the cover in place ALSO capture the bar. In order to adjust the chain tension you want the two nuts (10 mm) to be loose. Then tighten the chain via the tensioning screw, THEN tighten the nuts. Unless there is a lot of debris underneath the cover, you don't have to remove it to reinstall the chain. Just back off of the tensioning screw all the way. Then you'll have plenty of slack for the chain to slip it back over the drive sprocket and onto the bar. Then tighten it back it up until the chain just touches the bottom of the bar. The reason the chain falls off to begin with is because it gets too loose (chain heats up and stretches).

[@Wayondon]

Also raise the end of the bar upward before tightening those two nuts.

[@markh.2899]

Hey thanks! I was doing it wrong putting the chain on the bar, and then trying to put all back on the clutch -gears, doi! Thanks again!

[@mikek.3965]

Bravo, yep much easier to watch than open my book on this one. Ths!

[@kokyk8018]

Can you turn up the volume of your Camara thank you for sharing

[@teshuvahemmet3036]

Thanks for the information 👍

[@Jonnydog1]

Very helpful, thank you!

[@Jthabossman]

Thanks

[@jaredthomas7487]

Thanks!

[@markh.2899]

And, the bar has an adjustment screw I initially overlooked...

[@kidchristjustice4367]

Thanks ..

[@Mark-Marine]

You, by now, are aware you put the chain on reversed? Nonetheless, I'd like to see a video of you operating it as well as a review of it. 👍🏻👍🏻

[@Tettypat]

Im such a city slicker, i woulda just pulled out the manual before panicking for half an hour

[@donbanta8769]

😢