Here we go through a complete small engine rebuild. New piston, rings, cam, and vale lap job. disassembly and reassembly with heat cycle break in. Welcome to Man Time!
Пікірлер: 12
@geoffedwards1893 жыл бұрын
Thankyou! Just what I was looking for.
@Man-Time3 жыл бұрын
Awesome!
@fangtao70403 жыл бұрын
so happy to find your video,nice work:)
@darreng26393 жыл бұрын
If you know how to use the spring asset it works good
@jerrykraus3621 Жыл бұрын
When you were pushing out the pin on the gear holding the timing belt, did you push it from the front (facing camera) to the rear? Please advise..
@Man-Time Жыл бұрын
Sorry man. I honestly don’t remember
@jerrykraus3621 Жыл бұрын
@@Man-Time - no worries, the video was greatly appreciated Sir
@cousinssquadfamily2540 Жыл бұрын
how to replace crankshaft bearings gx35 ty
@09impala9 ай бұрын
Just remove the old ones and put the new ones back in
@adamsons28903 ай бұрын
Great video. The disc with the four holes that the pull cord assembly mounts on to will not turn. Hence it will not pull to start. Any suggestions. Thanks