How to rebuild the Power Trim on the Yamaha 4.2L V6 225 250 300hp

[@AchikSarih]

You are a wonderful man, my brother, May friend . Thank you very much for your outstanding work. Your human brother will benefit from it.

[@ATR-42]

two tips for people following this incredibly helpful video (I just did mine thanks to this video). If you dont have the hose Mike uses, you can use a short pvc pipe over the piston and rest the engine on it to hold the tool. If you dont want to use ATF there is branded Yamaha fluid for the trim tilt system, it is part # ACC-PWRTR-MF-32 and matched what came out of mine (also F300).

[@4RibsFishing]

Great tips!

[@grunner30]

I agree with ATR-42 Really grateful for your efforts. The part number help and all is great. I will say there is a super helpful and very simple way I've found to dispense ATF fluid. Use a piece of small tubing 1/4, 3/8, 1/2... as an artesian well kind of setup. Drill the cap with a uni-bit. Carefully drill it out to just slightly smaller than your tube. Cut at an angle on one end... makes it easier to push the tube through the cap and also allows the fluid to flow through from inside the bottle. Push the tubing all the way to the bottom of the quart bottle. Now you can simply squeeze the bottle of ATF same as Ketchup. Also, 3/16 or 7/32 drill through the top spout of a Dawn dish soap bottle and 1/4 tubing works great this way.

[@4RibsFishing]

Thank you for the kind feedback and sharing that tip. I will definitely be trying that next time.

[@ATR-42]

your content is incredibly helpful and clear, thank you for taking the time to put these together

[@4RibsFishing]

Glad you like them!

[@befmx31]

Just subbed. Not sure why I hadn't already.

[@4RibsFishing]

Thank you! I'm assuming this is my Mom or one of my best friends? LOL

[@befmx31]

@@4RibsFishing nope!

[@bostondan77]

I tried to cheap out when I did this and ordered a 30 dollar Pin Wrench AMT0004 from amazon, absolute garbage- didn't fit well, damaged my cylinder cap and broke off two of the tool pins, i ended up ordering the Marine Tech Tools pin wrench you recommended and it worked flawlessly.

[@4RibsFishing]

The marine tech tool is a quality piece.

[@AchikSarih]

Merci beaucoup ❤❤❤❤❤❤❤

[@befmx31]

9:40, funny!

[@scottgaines7571]

okay, what pump is that?

[@4RibsFishing]

It's a sureflo. Check for the link in the description.