How to remove 2007-20011 Chevy Tahoe fender.

How to remove 2007-20011 Chevy Tahoe fender. Removing this fender can be a bit challenging. the fender is part of the trucks structure. in this video i will give you all the insight you need.
f you have any questions leave them in the comments below and i will answer them all!
Please LIKE AND SUBSCRIBE!! I hope this video is helpful!
Be sure to check out my other videos in the links below!
⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️⬇️
BE SURE TO CHECK OUT MY OTHER HOW TO VIDEOS!
how to use body filler to repair a dent
• Auto body dent repair ...
How to repair and paint your bumper
• How to save money pain...
How to remove fisheyes from your paint job!
• How to remove fisheyes...
How to save a bad paint job
• How to save a bad pain...
Disclaimer:
Due to factors beyond the control of Garage Noise, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Garage Noise assumes no liability for any property or personal damage that may arise from doing a repair on your vehicle after watching any of my repair video's. Due to factors beyond the control of Garage Noise, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Again Any injury, damage or loss that may result from improper use of tools, equipment, or the information contained in this video is the sole responsibility of the user and not Garage Noise.

[@BRICEN18]

Nice video. Thanks for posting. I need to repair some rust. Now to figure out if I should repair or replace the whole fender.

[@GarageNoise]

Appreciate the support!

[@Jacoblivar]

I swear they had to make it so hard 😂

[@ramcholan2034]

Thanks for the video, I need to remove the fender to investigate water leak behind the fender around the place where the sound dampening material is present. Question: is removing bumper and front grill essential to remove bumper?

[@GarageNoise]

Grille for sure, I would just remove them not that difficult and less frustrating.

[@Nicole-br1hs]

Is this the same for an 08 suburban?

[@GarageNoise]

Yes

[@marlonreid6565]

Is the driver side any different

[@GarageNoise]

No sir

[@luisrg436]

Those 13mm are actually 1/2.