How To Remove a Guitar Neck Using a Jig

[@2011Matz]

An electric steamer delivers more consistent steam. Put a T in the line to relieve the pressure if necessary.

[@scottrill17]

The foam cutting rods seem to be the new standard to use. Steam is definitely the old fashioned method. The Kay is obviously a good choice for learning how to do guitar repair. How much did it cost you at Goodwill?

[@vindustrialguitars]

I haven’t tried the foam cutter technique, probably will however…I can’t remember how much it was. Probably around $150 or so. Thanks for the info!

[@Joe-mg5mz]

Thanks for the videos, they're the only ones I can find with a similar guitar as me. I'm working on '59 Kay "Western Rhythm" Guitar with a steel reinforced neck. I've got the neck pretty loose with just a hair dryer so far. Heard a few of the same pop sounds you did (also hoping it's glue). Did you use the steam rig for that other neck you showed briefly at the end? Edit: Just gave it another try using an iron this time, and it's now off!! A bit of wood stayed with the body of the guitar instead of with the dovetail, but it doesn't seem like a huge deal. Maybe the steam method would have avoided that. Either way, my project continues!

[@vindustrialguitars]

Wow good luck with the reset. Once the neck is off now the work begins….good luck! Thx for the comment!

[@darrylmurray2261]

Maybe try dry heat like with foam cutting rods. That way even if you miss the gap it still heats the block enough to soften the glue. Plus no waiting for everything to dry out...B^ )

[@vindustrialguitars]

I’m aware of that process, I’ll probably go that route next time. Thanks for the suggestion.

[@bldallas]

Was just going to say the same thing. That old school steam just never seems to be worth the potential water damage and overall mess.

[@greghopkins18]

I didn't have this much anxiety and anticipation when my wife was having a baby, phew. Thank God that's over 😜, well done. Thank you for this great tutorial video, it's clarified some points for me, cheers.

[@vindustrialguitars]

Haha thanks!