How to remove and clean Egr Volvo 1.6 D ( Diesel)

[@AlexAlex-ww9pf]

nice tutorial...I would also recommend you blow some high pressure air inside it....after all the cleaning i did, when i used air pressure inside it, chucks of coal came out of it

[@allaboutcars77]

Thank you 😃👍🏻, and thanks for the tip off the air pressure 😃👌🏻👌🏻

[@sparker9658]

Thank you posting this, very informative for my sons car.

[@allaboutcars77]

Your welcome 😁

[@TATEXPRESSINC]

Awesome Video!🎥

[@Chris-ot9jf]

Did mine tonight in the dark! Didn’t make much difference as you can’t really see it anyway but I’ll see how it goes tomorrow. Mines Turing on the anti skid warning light too which according to the local Volvo dealership is the egr. Apparently it turns this on because it hasn’t got full control of the engine power if the egr is faulty. If it’s not the egr I’ll push it in the lake near me and get a different car 🤣

[@gj91471]

Anti skid is Injectors need replaced... Common

[@Chris-ot9jf]

@@gj91471 it wasn’t, it was the EGR valve.

[@gj91471]

@@Chris-ot9jf but your injectors are on the way out... Cavitation. Happened on my identical Volvo...... Just bought the car secondhand.... Hazard lights came on when driving.... Injectors were not very pretty..... Diesel absorbs Air like a dry sponge Absorbs water. I now remove the Entrained Air from the fuel in the tank.... Massive fuel economy restoration and new injectors are spotless after 25000 miles

[@Chris-ot9jf]

@@gj91471 my injectors are fine, they’ve been checked. It was just an egr valve, simple 👍🏻

[@gj91471]

@@Chris-ot9jf it won't be long before the egr valve needs attention again..... Just saying... Best of luck 👍

[@gnulinux9802]

Hi, good tutorial. The gasket has a relieve border around the hole, it goes to the EGR side or to the collector pipe side? Thanks!

[@Gandeloft]

I came here looking for the answer to the same question.

[@s5msff152]

Did you disconnect the battery clamps before cleaning of Egr? Thanks beforehand..

[@CRt-d3h]

No need. 🙂

[@Mrme242]

Hi, should I use the seal when putting back ghe gasket?

[@Theviewer100]

Yes. If its ruined, get a new one

[@jerrykarlsson3978]

Did you need to calibrate the EGR after the install? My v Car shows fault code

[@allaboutcars77]

No totally not , did you put it right back together?

[@robertalexandrubaba7065]

Thank you!

[@allaboutcars77]

Your welcome 😁

[@gazsto9510]

Where do you get the new clamp? as the other one needs a proper tool and you can get replacements that can be screwed on.

[@allaboutcars77]

Hello, I get the clamp at the Peugeot garage because it is a psa engine

[@gazsto9510]

@@allaboutcars77 Thanks

[@Bousatsu1]

What size is the clamp you replaced please? Want to buy one before removing the old one, thanks

[@allaboutcars77]

bousatsu . You have to go to the Volvo or Peugeot dealer and ask for a clamp for the egr .

[@rajinder8644]

Hi I got same car it's just stopped in the way while driving, so I have to take egr electrical multiple plug out to sart the if I put back its stop my car straightway what ru think I need new egr or its work if I clean it

[@allaboutcars77]

Hello did you already Read the faults ?

[@allaboutcars77]

You can always clean IT first before beying a new one

[@frankjohansen3395]

Thank you for your advice, but where did U get the new clamp with the screw? I've been searching all over for it here in Norway, but can't find it. Plz give me a link to the shop. Another thing, when I open the top of my EGR a spring poped out, and now I''m not sure how this is mounted again. I have a 2010 Volvo V70 with the 1,6d engine

[@allaboutcars77]

Hello I get my in the Peugeot garage because it are all Psa engines

[@mkg3978]

hi , please could you tell me where i can buy this CLAMP i was search for long time ??

[@allaboutcars77]

Hello , I get my in the Peugeot garage

[@timorjanaase]

Where to buy this clamp? Part number?

[@allaboutcars77]

I bought it in the Peugeot garage because it's a PSA engine

[@TheAsa1972]

M8 can you tell me the name of the new clamp you used please

[@allaboutcars77]

TheAsa1972 you have to go to the Volvo or Peugeot dealer and ask for a clamp for the egr

[@TheAsa1972]

@@allaboutcars77 Thanks they make nothing easy do they

[@troo_story]

@@TheAsa1972 wha'st so fucking difficult about going to the dealer and getting one?

[@jdig1984]

I lost the gasket fell into engine bay and cannot find is there anything else I could use or will I have to get replacement seal

[@allaboutcars77]

It’s better to take a new one than

[@karelongena8299]

Volvo 1.6D aka PSA (Peugeot, ...) engine? Is it the same as used in my V70 1.6D ’drive’ from 2013?

[@allaboutcars77]

I don’t know for sure 🤷🏻‍♂️

[@Alexander_l322]

Yes it is. You will have the 115bhp. It’s the same engine in my 2011 1.6d DRIVe V70.

[@andymurphy9647]

M8 that clang at the beginning when took screws out must been gasket were could it have fallen to thst must be why my car not working

[@Στάθης-σ6ν]

Did u have any codes on the dash and u cleaned it ? I have noticed that my car have lost significant power after 3000rpm without any codes even in the Vida everything seems to operate absolutely right. Is there any difference after having it cleaned ? I have 120000miles and i have never got it cleaned

[@allaboutcars77]

Στάθης k I don’t have any codes on my dashboard , you will feel the difference after cleaning , your car will response better

[@mohammadjoome2428]

hi Στάθης k Did you fixed or found what was whrong with your car? I get the same problem now with my v50

[@Στάθης-σ6ν]

moh jame what’s the cars mileage ?? As I have mentioned I have 122000 miles. The dpf pressure was a bit high I made a trip and I drove with rpms so that the filter regen I also used a diesel additive and it improved a lot.

[@mohammadjoome2428]

@@Στάθης-σ6ν ok, thank you for answar

[@Στάθης-σ6ν]

moh jame no problem , if you fix inform us plz

[@RA-lh9uh]

i have V40 2015 D2 and my mechanic says there are 2 EGRs. where should the second one be??

[@allaboutcars77]

I don't know, on my car there was only one greets

[@RA-lh9uh]

@@allaboutcars77 i found it and it is only one yes. i had a lot of dirt in the radiator like part where antifreeze goes through. i cleaned it and now its fine

[@Hoxxz]

I cleaned my EGR using a ultrasonic washer. I removed the electric engine before putting in the bath. I reused the original clamp. When I put it back I used a pincers, worked like a charm. Final result after cleaning, the car is like brand new. Before when driving the rpm would go up and down. But that's gone now

[@naretab9738]

Hi I Chang diesel filter after that I can’t run the car????

[@naretab9738]

My car Volvo v50 2012

[@mcnealg15]

Needs bleeding as they dont have a pump in the tank to push diesel through

[@allaboutcars77]

Yes indeed

[@naretab9738]

@@mcnealg15 yes you are right . I use manual pump 😊. Just in v50 it’s no pump. Good experience in the life 👌

[@ericosterlund]

Hey mate, thanks for the video :) Can i ask what diameter the new ring that you bought was. Thanks again

[@allaboutcars77]

Ocean Element : hello I don’t know the diameter it is a original part of the psa group , so Peugeot part

[@aibhencasserly7613]

Did it fix the power reduced?

[@flappingarms9335]

@@aibhencasserly7613 that’s what I would like to know too

[@allaboutcars77]

You wil feel the difference

[@6xx3]

I did this and now my car starts up poorly, throws blue smoke out and stalls. Any ideas what could it be?

[@allaboutcars77]

Did you put it right back together?

[@6xx3]

@@allaboutcars77 Yes. Works now after some driving but I think egr still needs some adaption with computer

[@777lucifero]

Hello, is there any other way to clean it other than a carbcleaner? I'm broke.

[@777lucifero]

@@allaboutcars77 OK I tried to remove it today, i removed the 2 screws and trying to losen up the gasket (what tool did you use? or does it just come off? trying not to brake anything). Also, I can't manage to remove the wire on top, so i tried to just remove the top of the valve, but a spring came out... not sure how to place it back: imgur.com/a/5LfMQqn

[@allaboutcars77]

Simo no speciale tool needed if de clamp is loose you can remove it .

[@Andrzej_Krowiak]

Try with diesel fuel, that should works.

[@Alexander_l322]

Carb cleaner isn’t expensive! Maybe £4 a tin

[@mcnealg15]

Mr muscle oven cleaner

[@LazyBumHrky]

Which clap is theat , bro i rly need d name or code ...

[@allaboutcars77]

Hello, I get my in the Peugeot garage because it are psa engines

[@hmj90]

Hey. Greetings from Finland. I did egr cleaning but now the car does not start. Did you have the same problems or did the car work normally? I have volvo v50 1.6d 2008

[@allaboutcars77]

Henri T . Hello did you replug the electric plug ?

[@hmj90]

@@allaboutcars77 Yes. I also removed the battery before removing egr. There are no error codes either. Maybe I put the top part of it somehow wrong and now egr is open or closed all the time

[@bellomario84]

I have the same problem now..after cleaning..cant start my car

[@6xx3]

@@bellomario84 Did you get it fixed?

[@6xx3]

Did you get it fixed?

[@blameusa7082]

done all the while wearing a gold Rolex 😎😎

[@allaboutcars77]

Thank you , but I wish it was a Rolex 😃👌🏻

[@terminajuju2662]

When I was young I believed ecology was good, now I hate it lol

[@Gandeloft]

Ha, cheers mate!

[@ClemB1993]

Hi. Thank you so much for the tutorial, I will try it on my volvo 1.6d, it will probably turn off the "engine power reduced"

[@allaboutcars77]

ClemB1993 yes absolutely , you will feel the difference 😃👍🏻

[@Hoxxz]

I know it's like 2 years ago you wrote that but it might help someone else. I had the same problem. Previous owner used a cheap diesel filter. The electric cable didn't connect properly. So I replaced it with a original filter and I got rid of that problem

[@adrianconstantin2204]

can you give me the oem code for new clamp , with screw ? please

[@allaboutcars77]

Hello, I get my in the Peugeot garage because it are all Psa engines

[@ericosterlund]

Hey mate, I think I broke the electronic part of my EGR. It won't wind back automatically. What do you think? Thanks for the video :)

[@allaboutcars77]

Hello , did you take the black part of it ? You have to refit it on the right way , otherwise it won’t work .

[@ericosterlund]

@@allaboutcars77 hey thanks for the super quick response. My mechanism on the top part was different from another I saw in a video. Some how I got it back to auto winding, stuck it back on, and my car runs. Though for some reason still on power. I had changed the turbo recently but it doesn't seem to activate. I changed the MAF and the air filter, still no change. I'm starting to lose my mind over this 😬

[@feruhbasagic5229]

geputzt umweltfreundlich

[@Sebycretzu]

you cant see shit from this, camera all wobbly, please refilm this with a head mounted camera or a more stable video

[@allaboutcars77]

That's not possible, because I don't have the car anymore, sorry .greets