⛐ Check out our Garage to see what tools we use and recommend: www.amazon.com/shop/worldmechanics ⛐ Subscribe and hit the notification bell by the subscribe button for new videos: kzbin.info/door/J9xpq0qUZevSEdBSFqO2ow ⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys
@yingchen62365 жыл бұрын
Today I followed the video replaced my regulator. Thanks for the detailed info. As I asked in another comment, my window was stuck at the top position, I couldn't let the motor move the window down to the point to undo the locks. What I did was to first remove the 5 torx screws of the regulator, then the two tracks of the regulator could move, not completely free, but I managed to get some wiggle room to reach my hand in, and managed to release the two locks. It took me quite a while. The front one(close to engine compartment) was easy to release since the wiggle room was relatively big so I could bend my fingers, I really had a hard time to release the second lock, but I did it at the end. Then afterwards, the work was not that hard. In my case, I didn't need to remove the speaker, just needed to release the speaker wire for convenience. One more thing, to replace the glass in, I had to remove the inner glass seal piece first, then it turned to be a lot easier to see how the glass went in, and locked the glass in place. My car is a Focus 2012.
@yingchen62365 жыл бұрын
Very good and informative video! Thanks for posting. However, my case the window is stuck at the top position because of motor being dead. Is there any other ways to get the motor out?
@top_shott99173 жыл бұрын
Why are your replacing motor if it works lol most people's windows are not working which is why. We're trying to figure out how to remove it
@ethanburroff21515 жыл бұрын
This was great help! Thank you.
@marcogtzdev72504 жыл бұрын
What do you I do if the motor is dead and the window doesn’t roll down
@gordonmckevitt91318 ай бұрын
Let's face it it's a difficult job, what kind of cost are we looking at for this plz, average ??
@aidanholloway74875 жыл бұрын
Do you have to take of the positive and negative cables on the battery before doing this?
@daeelhaqqabdullah214610 ай бұрын
How do you do this if the window doesn’t move
@BeastBabyBeastYouTube3 жыл бұрын
So what do you do if the window motor broke and you can’t get the window to go down for removal?
@joeburke15082 жыл бұрын
there is also a screw behind the reflector which just unclips
@GeraldFaughn5 жыл бұрын
what if you cannot roll down the window? can you still get to the clips to remove the window?
@yingchen62365 жыл бұрын
see my late comment.
@redwhiteGT5004 жыл бұрын
If the motor is dead,remove the 4 silver screws that hold the tracks to the door, and the one black screw the hold the motor to the door. Move the track toward the front of the door,exposing the motor. Remove the 3 screws that hold the silver cover of the motor. Once that is off,you can pull out the armature, and then u can push the window down manually.
@zannosgrekos60033 жыл бұрын
There is also one more screw holding the panel in behind the red reflector. Also, this guy's video shows you how to remove just the motor and not the regulator, even with the window in the up position. kzbin.info/www/bejne/bXiUg4p4jM6lhqM