How to Remove Door Panels | 2006 Dodge Magnum SR-8

Watch as Brendan gives you a step by step guide on removing the door panel on a 2006 dodge magnum!
Sonic Electronix always strives to be the premiere online shopping destination for car electronics and other consumer electronics. Our slogan is "The X-Factor When Shopping for Electronics" and it is our goal to be just that. We're here to help you find solutions and great prices without sacrificing service.
www.sonicelectronix.com/
Sonic Electronix Facebook:
/ sonicelectronix
Sonic Electronix Twitter:
/ sonicelectronix
Sonic Electronix Instagram:
/ sonicelectronix

[@tjharden5559]

THANK YOU MAN!

[@loudestamen3279]

YAY! Thank you! And my MAGNUM is two toned just like the one in the video🎉

[@steadiguy]

Wow fantastic...and I'm understating it. This has been a great help. Thanks for your work showing the how in how to.

[@jeffh2125]

Note that when pushing in the pins that release the clips; if you push them too far in, that middle push pin will drop out the back side into the body of the door and hard to get out. Then you'll end up having to try to find replacement clips. Local Dodge dealer didn't carry them. Found some online and ordered along with the white ones across the top of the door that broke off. This plastic gets brittle over the years and will be fine as long as you don't mess with it like removing the door panel does. So, I started my door project just to immediately put it on hold until I get both kinds of replacement clips.

[@mr84ttop34]

What a big help! Thanks for sharing!!!!

[@Mikejones-pi9yu]

VERY HELPFUL DUDE!!! THANKS!!!

[@daconodad474]

Thanks for the step by step

[@rjmackenzie]

Thank you a ton. Just googled this as I was having a bit of trouble with mine. How the hell did you manage the camera AND the door? You're a master.

[@jamesjesse8285]

Oh man! Wish I'd have seen this before I took the panel from my 05 Magnum R/T. would have saved me 3 broken clips if I'd have known I could just press in the dang centers to release them. Oh well, new ones are in the mail

[@Abe-Froman]

thx bud. worked great for me

[@queend1146]

I have a 2007 Dodge Charger SRT and I putting Turn Signals on/in the mirror. Will I have to remove the door panel to get the side mirror off?

[@raymondherbert3960]

PRETTY GOOD. BUT IT WOULD BE MORE HELPFUL IF YOU SHOW A CLOSE UP ON HOW THE CLIPS ARE REMOVED WITH PICK.

[@Hernandsz]

Do you have a video on how to put it back

[@dannysoto3014]

Can you guys do a video for the exterior of front door handle 07 dodge charger?

[@mikelowry7480]

still helpful in 2018.

[@SrBu]

I think I broke my door Handel metal clip when I try to push it down it just pops up. I tried to tape it and the door open and closes good. Thanks

[@I1S1337]

Do all panel clips work the same way as for removing them?

[@jesusr7174]

Where Doni get the clips for the door? The green and the white ones?

[@rh_312]

Does anyone know what material Dodge used for the door panels?

[@heatherb4690]

Having a hard time getting the door panel back on the clips

[@nirosh89]

"Other than that"

[@bassmaniac7989]

еще одну под машиной потерял

[@raymondherbert3960]

IT WOULD BE GOOD TO ADVISE PEOPLE TO HAVE A CAN AVAILABLE TO PUT ALL CLIPS , SCREWS ,, AND PLASTIC COVERS IN SO THEY DON'T GET LOST.

[@XenoChrist1337]

Its SRT-8