How to remove high mount stop lamp 2013 2020 Mitsubishi Outlander

[@sirsergiy9536]

Thank you very much. You help a lot with your videos about Mitsubishi Outlander. I have the same car and the same color, 2018, 2 liter engine. Please continue. I am subscribed. Thumbs up.

[@gorbulas]

If you take of the interior trim center piece behind it, there are service holes to unclip it from the inside, with a flat tip screw driver.

[@the2menis1]

Please follow this advice, I was about to comment the same thing to try and save someone's back window

[@N2dH]

Thank you for another good video 👍

[@baleno2006]

Thanks for your support M J!

[@TS-vj9dc]

It's a well produced video but not the correct way to remove this light. Lift the tail gate remove the plastic trim at the top that's behind the light. Begin at one end it pops off when pulling gently. Behind this there are holes lined up with the metal tabs. They can be pressed in and slightly moved one by one so the bottom is released. Then lower the tail gate and use plastic tools to gently prise the light forward from the bottom. Take your time and it will come out easy.

[@muclaud]

,thanks man. It very helpful for my outlander. I found water leak on this

[@hishamudeenabdullah1799]

Thanks for the diy videos for outlander. Not many around. Can u share how to replace 3rd row seat belt holder clip. Got a replacement but unsure how to replace out the broken clip. Do I have to remove rear plastic panel where clip is fixed onto or it can jus be pry out immediately?

[@baleno2006]

Okay, stay tune.

[@baleno2006]

Thank you very much for your support.

[@hishamudeenabdullah1799]

Will keep a lookout 😅

[@jordy0005]

Lleva focos?

[@normanpriest9481]

do you know what you are doing????

[@thatank1058]

BAD JOB SHOWING US

[@jccooley5736]

Thanks but too much talking man. Should be 6 minutes not 13.

[@valerapurinsh4310]

Fack video 😢