Will share this on our social media, if thats ok of course.
@IAMASPANNER4 жыл бұрын
That’s absolutely fine thank you 😊
@EugeneCharles-l6w Жыл бұрын
Thankyou thankyou thankyou for your time.
@theprodriverinnovation3 жыл бұрын
Thank you 🙏
@IAMASPANNER3 жыл бұрын
You’re very welcome!
@Alexander_l3224 жыл бұрын
So you just took the old ones out and put new ones in? There was no need to code them or anything?
@IAMASPANNER4 жыл бұрын
Yes, no coding required
@ChrisjohnDONSON8 ай бұрын
Can i ask why the inlet injection cover has melted away .
@coccobill79827 ай бұрын
Usually when an injector leaks there is exhaust gasses leaking out around that injector. That can/ will blow away or melt that plastic cover.
@mikehughes39894 жыл бұрын
Any issues on start up after new injectors fitted?
@IAMASPANNER4 жыл бұрын
Hi Mike, no no issues at all 😁
@Peter5on.4 жыл бұрын
@@IAMASPANNER Hi do you remember tightening torque of those bolts for clamps that holds the injector?
@Richytbiscuit2 жыл бұрын
@@Peter5on. call ford
@user-nr8jt4jy4u Жыл бұрын
Salut, stii unde este releul bujiilor incandescente? Mulțumesc.
@BigGcapri3 жыл бұрын
hi, I don't mean to sound rude, but the video seem to miss out you initial pulling the injector out... did it really come out that easy or did it put up a fight.... also can I ask why you were changing these (I have a rattle/knock when cold, just wondered if you were experiencing the same) Thanks
@IAMASPANNER3 жыл бұрын
Hi Graham, not rude at all, yes you’re right and they weren’t very easy to remove at all. The problem was they were leaking so you get all the carbon crud build up that makes them difficult to remove. I’d be surprised if the injectors were causing a rattle though. Hope you get sorted!
@BigGcapri3 жыл бұрын
@@IAMASPANNER Hi Tolly, thanks for the reply, can I ask what symptoms you had?
@IAMASPANNER3 жыл бұрын
Diesel fumes coming into the car, the plastic cover was replaced as it had deteriorated and then the injectors had to be reseated.
@mickborthwick38143 жыл бұрын
@@IAMASPANNER did you use any pullers to remove them? Thanks
@IAMASPANNER3 жыл бұрын
@@mickborthwick3814 Just carefully used mole grips on the metal part of the injector. Fortunately I've never had one completely seized so far.
@petedougan56823 жыл бұрын
I have a leaking injector seal on cylinder 2 . Are seals easy to remove and replace ?
@IAMASPANNER3 жыл бұрын
If you can manage to remove the injector then yes the seals are the easy bit to change as long as they don’t get stuck seated in the engine. Do your best to clean where it seats without scratching it up, I usually use a microfibre cloth wrapped round a screwdriver.