How to Repair a Drive Shaft Using Forming Techniques

[@hernaldopadilla2021]

Buenas tardes , es posible rellenar el cuerpo interno de una bomba de alta presion de fluido de aceite , cabe hacer mención que es de aluminio , Nicaragua.

[@punchole]

Is it good heat resistance?

[@mumbles552]

Would this material work to repair a shaft which has a groove cut into by the lip of oil seal?

[@belzona]

Hello and thank you for your question! If the grove is on the the shaft independent where it is, with the correct access to the area, the repair can be done. Let us know if any other questions. Best regards, Belzona Team

[@mclmm6773]

A metabo shaft/tube polisher really speeds up the surface finishing.

[@kimhemsang8921]

good afternoon you have representatives here in Brazil obrigado

[@belzona]

Hello and thank you for your interest! Yes, please feel free to contact the Belzona Authorized Distributor in Brazil: Hita Comércio e Serviços Rua Antonio Conselheiro, 569 Dias Dias d'Ávila, Bahía, 42850-000, Brazil Telephone:[phone] Fax:[phone]

[@belzona]

Thank you!

[@kimhemsang8921]

Obrigado

[@kimhemsang8921]

É um durapox Brasil 🇧🇷

[@mostafamahmoudshendy2993]

how much time the blezona take to be solid ?

[@belzona]

Hi Mostafa, A full mechanical cure is achieved in 24 hours at 20°C. Movement, machining and light loading times vary and are all affected by the ambient temperature. There's is a really handy cure time table in section four of our instructions for use document that can be found at the link below. This will give you a better understanding of your specific cure times. www.belzona.com/viewfile.aspx?id=51037 Let me know if there is anything else I can help with! Many thanks, Miles

[@beamerboy9273]

Просто наждачкой сшлифовать лишнее?) Но ведь... геометрия вала....

[@belzona]

Геометрия вала осталась прежней. Изделие отшлифовано, геометрия сохранена. Продукты Belzona не утяжеляют вал и при шлифовке становятся достаточно гладкими.

[@beamerboy9273]

@@belzona показали бы тогда замеры штангенциркулем как вам удалось наждачкой на глаз вывести цилиндрическую форму да еще и попасть в допуски по диаметру вала 🤣

[@robbysamosir6113]

oke up